Omron CJ1W-SCU32 Operation Manual page 442

A Standard System Protocol
Additional Information
• The following settings must be made together with this sequence; they cannot be set sepa-
rately.
Lower limit, upper limit
Reference value, analog output scale number
Data output conditions, data output timer
• The limit value and reference value can be set to 3 digits for the integer portion and to 4 digits
for the decimal portion.
Measurement Condition Release (4000-series) (Sequence No. 432
(Hex 01B0))
This sequence clears the measurement conditions that have been set.
Send Data Word Allocation (3rd Operand of PMCR(260))
The send data word allocation is similar to that of sequence No. 431 (Measurement Condition Set).
However, only the setting Yes/No flags at +19 to +24 from the send data leading word can be used.
Receive Data Word Allocation (4th Operand of PMCR(260))
None.
Additional Information
• The following conditions are used when the measurement conditions are released: Segment
becomes 1 and the measurement interval becomes 1.
• The following settings cannot be cleared separately using this sequence. They all must be
cleared at the same time.
Lower limit, Upper limit
Data output conditions, Scheduled print timer
• The scale (SCL) and data output timer (PRT) cannot be cleared.
• This sequence can be used for the 3Z4L-4000 Series only when pin 8 on DIP switch SW2 is
turned ON.
Measurement Condition List Request (4000-series)
(Sequence No. 433 (Hex 01B1))
This sequence requests the measurement condition settings that have been set and other settings.
Send Data Word Allocation (3rd Operand of PMCR(260))
None.
R-108 CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)