Indicators Used For The Loopback Test - Omron CJ1W-SCU32 Operation Manual

4
Reconnect the Controller power, restart the Serial Communications Unit (change the system-
defined variable _CJB_CBU**Restart to TRUE), or restart the serial port (change the system-
defined variable _CJB_SCU**P1ChgSta or _CJB_SCU**P2ChgSta to TRUE).
5
Set the Loopback Test Switch of the Software Switch to TRUE.
To end the test, set the switch to FALSE.
*_P1_LbtTestTrigCmd for port 1
*_P2_LbtTestTrigCmd for port 2
Refer to 2-3-3 Device Variable for CJ-series Unit for Software Switches.
6
Use the loopback status to check the results.
Refer to 8-2-2 Device Variables for CJ-Series Unit for Status.
System-defined variable
_CJB_CBU**Restart
_CJB_SCU**P1ChgSta
_CJB_SCU**P2ChgSta
8-1-4

Indicators Used for the Loopback Test

When the test is being executed, the indicators shown below will flash. Use the Loopback Test Status in
the Protocol Status to check whether or not the test is executed normally.
Port 1: SD1/RD1 indicator
Port 2: SD2/RD2 indicator
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
Type R/W Name
BOOL RW CPU Bus Unit
Restart Bits
(** indicates the
unit number
(00-15).)
BOOL RW Serial Communica-
tions Unit **, Port
1/2 Settings
Changing Flag
(** indicates the
unit number
(00-15).)
8 Loopback Test
Function
The CPU Bus Unit restarts when the
variable changes to TRUE. (The sys-
tem will restore the variable to FALSE
after restart.)
The number at the end of each sys-
tem-defined variable corresponds to
the Unit No.
• The flag changes to TRUE when
changing the setting of the corre-
sponding port or executing a Serial
Port Setting Change instruction.
• The flag returns to FALSE when an
event is sent from the Serial Unit
when settings are changed.
• It is also possible for the user to set
the flag to TRUE and notify the
Serial Unit change in serial port
setting.
8
8-3