Omron CJ1W-SCU32 Operation Manual page 58

1 Introduction
Item
Message unit Data attributes
contents of addresses
and data in
send/receive
messages
Error check codes
Maximum length of
send/receive messages
Maximum number of
data attributes regis-
tered in one message
Maximum number of
write data attributes
registered in one mes-
sage
Trace function
*1 The baud rate and the communications distance sometimes depend on the remote device. Confirm them in the
operation manuals for the connected devices.
*2 When you use 2-wire RS-422A/485 communications in Protocol Macro Mode, set only modem controls for the
transmission control parameters, and do not use RS/CS flow controls.
*3 The data size is the number of bytes on the transmission path.
*4 The CX-Protocol can be used to register up to 96 attributes per message.
*5 A macro syntax error will occur when the protocol macro is executed if more than 31 write attributes are regis-
tered in one message.
1-18
Vari- Y Linear expres-
ables sion including
repeat counter
Wild card
Word designa-
tion
LRC, LRC2, CRC-CCITT, CRC-16, SUM, SUM1, and SUM2 can be calculated.
1,000 bytes. (A maximum length between 200 and 1,000 bytes can be set in the
Setup Area.)
96 attributes (*4)
30 attributes (*5)
A total of up to 1,700 bytes (characters) of time-series data can be traced in
send and receive messages.
Changes to the step No. and control signals such as RS and CS can also be
traced.
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
Description
aN + b a: 0 to 1000; b: 1 to 1000
N: Repeat counter value
* Can be received regardless of
the length (only in receive mes-
sages)
Read word Specify by the
(memory used input variable:
for CJ-series SrcData of the
Units to send SendPMR
data) instruction.
Specify the
area by a link
word.
Directly spec-
ify the memory
used for CJ-
series Unit
Set leading
address + n
(The linear
expression aN
+ b, including
repeat counter
N, is also pos-
sible for n.)