C–Midi Filter - Korg KROSS Parameter Manual

Combination mode
5: C–MIDI FILTER
These settings allow you to apply filters to the MIDI data that will
be transmitted and received by each timbre 1–16. For example
even if two timbres are being played by the same MIDI channel,
you can adjust settings so that the damper pedal will apply to one
but not the other.
On (checked): Transmission and reception or reception (After
Touch) of MIDI data is enabled.
If Status (COMBI> PROG) is INT, the effects of the checked
items will be applied to the timbre's program when the controllers
of the KROSS are used or when MIDI data is received. (Effect
Dynamic Modulation is not affected by these settings.)
In the case of EXT or EX2, operating a controller on the KROSS
will transmit MIDI data on the channel of that timbre. MIDI
transmission/reception settings for the entire KROSS can be made
in MIDI Filter (G–MIDI> FILTER).
The MIDI Filter 3 contains MIDI filters for assignable controllers
(whose function can be set by the user), and if these are assigned to
MIDI control changes, the filter settings will affect those control
changes. In this case, if the same control change has been assigned
in MIDI Filter pages 1–2, the settings in MIDI Filter pages 1–2
will take priority. Also, if the same control change is assigned to
two or more controllers in the MIDI Filter pages 3, checking any
one of them will enable that control change.
Off (unchecked): Transmission and reception of MIDI data is
disabled.
Note: MIDI CC# = MIDI control change message numbers.
5–1: 1 (MIDI Filter1)
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres.(see page 71)
Enable Program Change
Specifies whether or not MIDI program change messages will be
transmitted and received.
Enable After Touch
Specifies whether or not MIDI after touch messages will be
received.
Enable Damper
Specifies whether or not MIDI CC#64 hold (damper pedal)
messages will be transmitted and received.
Enable Portamento SW
Specifies whether or not MIDI CC#65 portamento on/off
messages will be transmitted and received.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
82
5–2: 2 (MIDI Filter2)
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres.(see page 71)
Enable Pitch Bend as AMS
Specifies whether or not MIDI pitch bend messages (the pitch
bend wheel settings) will be received to control the AMS effect
assigned to Pitch Bend. (This is not a filter for MIDI pitch bend
message reception.) For more information, please see "Alternate
Modulation Sources (AMS)" on page 291.
Enable Mod.Wheel:CC#01
Specifies whether MIDI CC#1 (the pitch bend wheel setting) will
be transmitted and received.
Enable JS–Y CC#02
Specifies whether MIDI CC#2 will be transmitted and received.
Enable Ribbon CC#16
Specifies whether or not MIDI CC#16 will be transmitted or
received.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
[Off, On]
[Off, On]
[Off, On]
[Off, On]
[Off, On]
[Off, On]
[Off, On]
[Off, On]