Korg KROSS Parameter Manual page 109

Auto Song Setup
The Auto Song Setup function copies the settings of a program or
combination to a song, and puts you in record-ready mode. Then
you can simply press the SEQUENCER
button to begin recording immediately. This lets you seamlessly
move from playing a program or combination to producing a song.
For example, if you've been using the drum track or arpeggiator
and have come up with a phrase or an idea, this function lets you
easily turn your inspiration into a song.
Procedure (example: Combination mode)
1. Enter Combination mode.
2. In COMBI page, select the desired combination and edit
the Arpeggiator etc. as desired.
Note: If you want to save the edited state of the combination, use
the Write Combination function.
3. Press the SEQUENCER  (REC) button. Alternatively,
select the function "Auto Song Setup."
The Setup to Record dialog box will appear.
4. To execute the Auto Song Setup function, press the
SEQUENCER  (REC) button or the OK (MENU) button.
If you decide not to execute, press the Cancel button.
You will automatically move to Sequencer mode, and the settings
of the combination will be copied to the song.
The first unused song will be the copy-destination song.
Contents automatically copied from a combination
The copied contents will be the same as when you execute the
function Copy From Combination with the following settings in
the dialog box. (see page 138)
• IFXs, MFXs checked
• Auto Adjust Arp setting for Multi REC checked
Contents automatically copied from a program
The result will be the same as if you used the Copy From Program
function and MULTI REC with the following settings.
(see page 95)
• IFXs, MFXs checked
• StepSeq checked
• Arp checked
• To set to Track 01
• Arp set to A
• Check the Drum Track check box, and choose Track 10
• Check Recording Setup Multi REC
• Set the Play/Rec/Mute setting to REC for tracks 01, 10 and 16
(see page 110).
5. The KROSS will automatically enter record-ready mode,
and the metronome will sound according to the Metronome
setting (SEQ> REC).
6. Press the SEQUENCER
begin realtime recording. To stop recording, press the
SEQUENCER (START/STOP) button once again.
(START/STOP)
(START/STOP) button to
An overview of Sequencer mode
The Undo function
When you perform realtime recording, or track editing, this
function allows you to make before-and-after comparisons.
If you record when the Undo function is on (checked), Undo will
be turned off. That musical data now becomes the musical data
that will be selected when Undo is off.
Operations where Undo is available
In general, track event data can not be returned to its original state.
Comparing song parameters is possible only during song editing
(when executing a function).
• Recording to a MIDI track
• Track Edit
All commands except for the following functions: Memory
Status, Link Edit Measure to Current, Solo Setting, FF/
REW Speed and Set Location of the S–TRACK EDIT page.
• Song Edit
SEQ–S–MIDI pages: Delete Song and Copy From Song
functions
The program will not be affected by the Undo, and will not
return to its prior state.
Operations where Undo is not available
• Editing song parameters
• functions other than those listed under "Operations for which
Undo is available" above.
101