Vintage Chorus - Korg KROSS Parameter Manual

High EQ
HEQ [dB] –15.0...+15.0
Gain [dB]
–Wet...
←
Wet/Dry –99 : 1, Dry,
99 : 1...Wet
Src Source Off...Tempo
Amt Amount –100...+100
L Pre Delay [ms]
R Pre Delay [ms]
Setting the left and right delay time individually allows you to
control the stereo image.

065: Vintage Chorus

This models a famous chorus unit that was built into a guitar amp.
Although it does not provide a chorus and vibrato select switch,
you can use the "Wet/Dry" and "Bus" settings to produce their
effect. The "Speed," "Depth," and "Manual" parameters allow an
even wider range of sounds than the original unit.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Right
LFO
Paramter Value
←
Speed [Hz] 0.10...10.0
←
Depth 0...100
←
Manual 1...100
Output
Out Mode 0, 1
Mode
Dry, 1:99 ...
←
Wet/Dry
99:1, Wet
Src Source Off...Tempo
Amt Amount –100 ... +100
Wet/Dry
Output Mode
For the master effects, "Wet/Dry" adjusts the output level of the
effect sound.
When "Output Mode" is Mono, L and R will output the same
vibrato effect. Normally, you'll produce a chorus effect by
adjusting the return level to mix the processed sound with the
direct sound. If you turn "Bus" Off and adjust the settings so that
none of the direct sound is mixed in, a vibrato effect will be
produced.
If "Output Mode" is Stereo (L-Dry & R-Wet), the direct sound will
be panned to L, and the effect sound will be panned to R for
output. Normally, you'll mix the direct sound and effect sound by
adjusting the return level, applying chorus only to the R channel,
and producing a stereo effect that's spread to the left and right. If
you turn "Bus" Off, pan the direct sound and effect sound to the
left and right, and output them from stereo speakers, the effect
sound and direct sound will be panned in stereo, producing a clear
and spacious chorus effect.
Sets the gain of the
High EQ
Sets the balance
between the effect
and the dry input
p.226
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
Wet / Dry
Stereo
(L-D&R-W)
Output Mode
Mono
Chorus
Wet / Dry
Explanation
Sets the speed of LFO
Sets the modulation
depth
Sets the sweep
frequency
Sets the outpu mode
0: Mono
1: ST (L-D& R-W)
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
Single size effects 065: Vintage Chorus
066: Black Chorus
This models a Danish-made stereo chorus + pitch modulator &
flanger. Although this effect was originally intended for guitar, it
was also used by numerous keyboard players. Used with electric
piano, it produces a distinctive tone.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Chorus
Input Gain
Right
LFO
Paramter Value
←
Speed [Hz] 0.10...10.0
←
Width 0...2
Chorus
←
Mode Pitch Mod
Flanger
←
Intensity 1...100
←
Input Gain 1...1000
Output
Out Mode 0, 1
Mode
Dry, 1:99 ...
←
Wet/Dry
99:1, Wet
Src Source Off...Tempo
Amt Amount –100 ... +100
Mode
Intensity
Increasing the "Intensity" value will strengthen the modulation
effect. This controls the effect, direct, and feedback values. The
values that are controlled will depend on the "Mode" setting.
Wet / Dry
Mode & Intensity
+
Mono
-
Output Mode
+
Stereo
Wet / Dry
Explanation
Sets the LFO speed
Sets the LFO
modulation depth
Select a mode
Sets the intensity of
LFO modulation
Sets the input gain
Select a output mode
0: Mono
1: Stereo
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
253