Tone Adj (Tone Adjust) - Korg KROSS Parameter Manual

Sequencer mode
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, "–" is shown.
114
2–2: TONE ADJ (Tone Adjust)
The Tone Adjust function and EG Adjust function let you make
simple changes to the sound by adjusting the main program
parameters for each track's program, such as the filter or the filter
and amp EG.
The result of editing the Tone Adjust and EG Adjust parameters is
saved in the song.
This lets you adjust the sound of each timbre without modifying
the original program sounds. For example, it's easy to brighten the
sound of a track by raising its cutoff frequency so that it will fit
better with the other sounds of the song.
Tone/EG Adjust settings and MIDI control changes
Many of the program parameters that are affected by Tone Adjust
can also be modified via MIDI CC.
Adjustments via Tone Adjust and changes via MIDI CC are
always enabled; these two are combined to determine the actual
change that is applied.
The MIDI control change numbers (CC#) corresponding to each
Tone Adjust parameter are shown below.
Cutoff: CC#74
Resonance: CC#71
EG Intensity: CC#79
Vel. Intensity: Not supported
Attack: CC#75
Decay: CC#75
Sustain: CC#70
Release: CC#72
See page 311, 317
Most of these functions adjust (scale) the parameter settings of the
timbre programs. Unless otherwise noted, "scaling" means that the
parameters are at their programmed values when the controller is
at 64, at their minimum when the controller is at -99, and at their
maximum when the controller is at +99. For another look at this,
please see the diagram below.
CC scaling of parameters
99
Parameter
Value
As Programmed
00
0 64 127
CC Value