Applying The Midi Message Filter - Korg Kaossilator Pro+ Owner's Manual

Setting the MIDI channel
Here's how to set the KAOSSILATOR PRO+'s
MIDI channel.
1. Hold down the SHIFT button and press
PROGRAM MEMORY 4 (MIDI).
2. Use the PROGRAM/BPM knob to select
"MSSG," and then press the PROGRAM/BPM
knob.
3. Use the PROGRAM/BPM knob to select
"GL.Ch" (Global MIDI channel), and then press
the PROGRAM/BPM knob.
The currently-specified MIDI channel is dis-
played. Use the PROGRAM/BPM knob to
change the MIDI channel.
4. If you want to store the setting, press the
WRITE button. If you don't want to store the
setting, press the SHIFT button.
TIP: So that data can be sent independently to multiple
MIDI devices via a single MIDI cable, MIDI has sixteen
channels (1–16). If the transmitting device is set to
MIDI channel "1," the receiving device must also be
set to channel "1" in order for MIDI messages to be
received.
Changing the control change numbers
or note numbers
1. Hold down the SHIFT button and press
PROGRAM MEMORY 4 (MIDI).
2. Use the PROGRAM/BPM knob to select
"MSSG," and then press the PROGRAM/BPM
knob.
3. Use the PROGRAM/BPM knob to select the
control of the assignment that you want to
change, and then press the PROGRAM/BPM
knob.
Transmit/receive note messages
–
Transmit control change messages
Touch pad X-axis
Touch pad Y-axis
Touch pad on/off
PROGRAM VOLUME knob
GATE ARP TIME/SPEED slider / Gate Time
GATE ARP TIME/SPEED slider / Gate Speed
GATE ARP button
4. Use the PROGRAM/BPM knob to specify a
control change number or note number in the
range of 0 127. If you choose a control number
–
that has already been assigned to a different
controller, the decimal point will light-up. If you
assign that same number, this controller will
transmit and receive the same control change
message as the other controller.
5. If you want to store the setting, press the
WRITE button. If you don't want to store the
setting, press the SHIFT button.

Applying the MIDI message filter

1. Hold down the SHIFT button and press
PROGRAM MEMORY 4 (MIDI).
2. Use the PROGRAM/BPM knob to select
"FiLt," and then press the PROGRAM/BPM
knob.
3. Use the PROGRAM/BPM knob to select the
message that you want to filter, and then press
the PROGRAM/BPM knob.
You can filter the transmission and reception of
(clock),
(control change),
(system exclusive) messages.
4. Use the PROGRAM/BPM knob to disable
or enable the message. Choose
abled; i.e., filtered) or
LOOP REC BANK buttons
(program change),
(note), and
(Enabled; i.e., not
(Dis-
21