Pref 2(System Preference 2) - Korg KROSS Parameter Manual

Several minutes before the power turns off, a dialog box will
appear with a count-down indicating the time until the power turns
off. If you don't want the power to turn off, press the KROSS's
display or keyboard, or use a button or knob. Auto power-off will
be reset, and the same message will appear once again if no user
input is performed for the specified length of time.
Disable: Auto power-off will be disabled. The power will not turn
off automatically.
Battery Type
After you've installed the batteries, turn on the power and specify
the type of batteries you're using.
Alkaline: Alkaline batteries: Alkaline
Ni-MH: Nickel-metal hydride batteries: Ni-MH
Auto Save (Auto Battery Save)
On (checked): The brightness of the rear panel KORG logo
illumination is decreased to save power. The default setting is On.
Off (unchecked): The same brightness is specified whether the
unit is operating on batteries or with the AC adapter. The
brightness of the rear panel KORG logo illumination is determined
by the setting of the KORG Logo Light parameter.
LCD Contrast
This adjusts the contrast of the display.
KORG Logo Light - Brightness
This specifies the brightness of the rear panel KORG logo
illumination. If this is Off, the logo is unlit.
[Alkaline, Ni-MH]
[Off,On]
[–64...+63]
[Off, 1(Dark)...9(Bright)]
0: GLOBAL 0–4: PREF 2(System Preference 2)
0–4: PREF 2(System Preference 2)
Audio Play Level (AudioPlay/Pad/USB)
This temporarily lowers the playback volume of the audio song,
pad sampler, and USB audio input.
Note: This is linked with the Set Play Level parameter of the
AUDIO RECORDER SETUP dialog box. It can be set from either
place. This simultaneously controls the pad sampler and USB
audio input as well as the audio song. (→p.195)
Note: When the power is turned off, the original volume setting
returns.
Auto Rec Start
[Off, Note-On, SEQ START, Input Low, Input High]
This specifies how recording starts for the audio recorder and the
pad sampler.
This is linked with the Auto parameter of the AUDIO
RECORDER SETUP dialog box and the SAMPLE RECORDING
dialog box.
Off: From the record-standby state, press the MENU (Rec Control
) button or the AUDIO REC
recording.
Note-On: Recording will start when you play the keyboard from
the record-standby state.
SEQ START: Recording will start when you press the
SEQUENCER (START/STOP) button from the record-
standby state.
Input Low: Recording will start when the audio input level
exceeds approximately -18 dB while in the record-standby state.
Input High: Recording will start when the audio input level
exceeds approximately -6 dB while in the record-standby state.
Changes to this setting are always saved. You don't need
to execute Write Global Setting.
0–1...4: FUNCTION
V
• 0: Write Global Setting see page 176
• 1: Load Preload/Demo Data
• 2: Change all bank references
• 3: Half Damper Calibration
• 4: Update System Software
For more information, please see the "Global, Media:
FUNCTION" section on page 176.
[-42, -36, -32, -30, -28, -26...0dB]
button to start
see page 176
see page 177
see page 177
see page 177
159