St. Wah/Auto Wah (Stereo Wah/Auto Wah) - Korg KROSS Parameter Manual

011: St. Wah/Auto Wah (Stereo
Wah/Auto Wah)
This stereo wah effect allows you to create sounds that range from
vintage wah pedal simulations to auto-wah simulations, as well as
a wide variety of other settings.
Stereo In - Stereo Out
Left
Envelope Sens
+ Envelope Shape
Response
D -mod
LFO
Right
Paramter Value
Frequency
Freq Btm 0...100
Bottom
Frequency
Freq Top 0...100
Top
←
Resonance 0...100
←
LPF Off, On
Auto,
Sweep Sweep Mode Dmod,
LFO
Src Source Off...Tempo
Resp Response 0...100
Envelope
Env Sens 0...100
Sens
Envelope
Env Shape –100...+100
Shape
LFO Freq
LFO [Hz] 0.02...20.00
[Hz]
Src Source Off...Tempo
–20.00...
Amt Amount
+20.00
BPM/MIDI
MIDI Sync Off, On
Sync
MIDI,
←
BPM 40.00...
300.00
←
Base Note ...
←
Times x1...x32
←
Out Level 0...100
Src Source Off...Tempo
Amt Amount –100...+100
Dry, 1 : 99...
←
Wet/Dry
99 : 1, Wet
Src Source Off...Tempo
Amt Amount –100...+100
Single size effects 007: St.Parametric 4EQ (Stereo Parametric 4EQ)
Wet / Dry
Wah
Sweep Mode
Auto
D-mod
LFO
Wah
Wet / Dry
Explanation
Sets the lower limit of
the wah center
frequency p.223
Sets the upper limit of
the wah center
frequency p.223
Sets the resonance
amount
Switches the wah low
pass filter on and off
Selects the control
from auto-wah,
modulation source,
and LFO p.223
Selects the
modulation source
for the wah when
Sweep Mode=Dmod
Sets the response
speed when Sweep
Mode = Auto or Dmod
Sets the sensitivity of
auto-wah p.223
Sets the sweep curve
of auto-wah p.223
Sets the speed of the
LFO p.223
Selects a modulation
source for LFO speed
Sets the modulation
amount of LFO speed
When this is on, the
LFO speed is set by
BPM, Base Note, and
Times, instead of
Frequency p.223
MIDI syncs to the
system tempo; 40–
300 sets the tempo
manually for this
individual effect p.223
Selects the type of
notes that specify the
LFO speed p.223
Sets the number of
notes that specify the
LFO speed p.223
Sets the output level
of the effect sound
Selects the
modulation source
that will control the
effect output level
Sets the modulation
amount of the effect
output level
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
Frequency Bottom
Frequency Top
The sweep width and direction of the wah filter are determined by
the "Frequency Top" and "Frequency Bottom" settings.
Frequency Frequency
Top=75 Wah
Bottom=60
Woo
Bottom=25
D
Higher
Zero Max
Frequency
Frequency
Wah
Bottom=75
Top=75
Woo
Woo
Bottom=25
Envelope
Time
Sweep Mode
This parameter changes the wah control mode. Setting "Sweep
Mode" to Auto will select an auto-wah that sweeps according to
envelope changes in the input signal level. Auto-wah is frequently
used for funk guitar parts and clav sounds.
When "Sweep Mode" is set to Dmod, you can control the filter
directly via the modulation source in the same way as a wah pedal.
When "Sweep Mode" is set to LFO, the effect uses LFO to sweep
in cycle.
Envelope Sens
This parameter sets the sensitivity of the auto-wah. Increase the
value if the input signal is too low to sweep. Reduce the value if
the input signal is so high that the filter is stopped temporarily.
Envelope Shape
This parameter determines the sweep curve for the auto-wah.
Level
value = 0...+100
value = 0...-100
LFO Freq [Hz]
BPM/MIDI Sync
When "BPM/MIDI Sync"=Off, the LFO speed uses the "LFO
Freq [Hz]" parameter setting. When "BPM/MIDI Sync"=On, the
LFO speed follows the "BPM," "Base Note," and "Times"
settings.
BPM
Base Note
Times
One cycle of LFO sweep is obtained by multiplying the length of a
note ( ... ) (selected for "Base Note," in relation to the tempo
specified in "BPM," or the MIDI Clock tempo if "BPM" is set to
MIDI) by the number specified in the Times parameter.
Sweep Mode=D-mod
Wah
Woo
Top=30
-mod
D -mod
Higher
Zero Max
Sweep Mode=Auto
Wah Wah
Envelope
Top=25
Woo
Envelope Time
Envelope Shape
Envelope
Time
223