Scan Zone - Korg KROSS Parameter Manual

Hide thumbs Also See for KROSS:
Table of Contents

Advertisement

Program mode
Swing
This adjusts the timing for the step numbers that are specified by
Steps per Beat for Swing.
When Resolution =
, Step Per Beat = x1
Step 1
2
3
–50
Swing
You can also use PROG> ARP page MOD [SWING] to control
this.
Note: Swing has no effect on the preset patterns.
Sort*
This specifies the order that the notes you press will be
arpeggiated.
On (checked): Notes will be arpeggiated in the order of their
pitch, regardless of the order that you pressed them.
Off (unchecked): Notes will be arpeggiated in the order that you
pressed them.
Sort
OFF, UP
Sort
ON, UP
Latch*
Specifies whether or not the arpeggio will continue playing after
you take your hand off of the keyboard.
On (checked): The arpeggio will continue playing after you
remove your hand from the keyboard.
Off (unchecked): The arpeggio will stop when you remove your
hand from the keyboard.
Key Sync.*
Specifies whether the arpeggio pattern will begin when you press a
key, or whether it will always follow the (Tempo) (PROG>
MAIN).
On (checked): The arpeggio pattern will start playing from the
beginning when a note-on occurs from a condition where no keys
are pressed. This setting is suitable when you are playing in
realtime and want the arpeggio to play from the beginning of the
measure.
Off (unchecked): The arpeggio pattern will always play according
to the (Tempo).
Keyboard*
This specifies whether the notes you play on the keyboard will be
sounded as usual in addition to being sounded as part of the
arpeggio.
On (checked): The notes you play will be sounded on their own,
in addition to being sounded as part of the arpeggio. For example
if you simultaneously press two or more notes, they will be
sounded as usual in addition to being played as arpeggiated notes.
Off (unchecked): Only the arpeggiated notes will be heard.
Note: You can use the FUNCTION Copy Arpeggiator to copy
arpeggiator settings from another program or combination (see
page 65).
52
[–100...+100(%)]
4
5
6
7
8
–25
+25
13–2: SCAN ZONE
9
+50
KEY
This shows the Scan Zone setting.
Bottom (Bottom Key)
Top (Top Key)
[Off, On]
These parameters specify the range of notes (keys) where the
arpeggiator will function. Top Key is the upper limit, and Bottom
Key is the lower limit.
The arpeggiator will operate when you play keys within the
specified range. Keys outside of this range can be played in the
normal manner, and will not be affected by the arpeggiator.
For example if you set Pattern to Preset:, check Latch, set Top
Key to B3, and Bottom Key to C-1, playing a note B3 or lower
will trigger the arpeggiator. Since Latch is on, the arpeggio will
continue even after you release the keys. You can use the C4 and
higher keys to play conventionally along with the arpeggio
sounded by the B3 and lower keys. To change the arpeggio, play
keys in the range of B3 and below.
VELOCITY
[Off, On]
Bottom (Bottom Velocity)
Top (Top Velocity)
Specifies the range of velocities where the arpeggiator will
function. Top Velocity is the upper limit, and Bottom Velocity is
the lower limit.
The arpeggiator will operate when you play notes with a velocity
(playing strength) that is within the specified range. Notes played
[Off, On]
with a velocity outside this range will be sounded normally,
without regard to the arpeggiator.
Note: You can also set the note value and velocity value bythe
keyboard (see page 13 of the Operation Guide).
13–1, 2: FUNCTION
V
• 0: Write Program, Write/Initialize Program
• 1: Solo Setting
• 2: Compare
• 3: Auto Song Setup
[Off, On]
• 4: Add to Favorite
• 5: Copy Arpeggiator
For more information, please see the "Program: Function" section
on page 63.
see page 63
see page 64
see page 64
see page 64
see page 65
[C–1...G9]
[C–1...G9]
[001...127]
[001...127]
see page 63

Advertisement

Table of Contents
loading

Table of Contents