Voice - Korg KROSS Parameter Manual

5–5: VOICE
Specify the voice assign, pan, and effect routing etc. for each key
of the drum kit.
Drum Kit Select
KEY
Assign
See "5–1: DS 1 (Drumsample 1)" on page 170
VOICE ASSIGN
Single Trigger
On (checked): Even when the same key (note) is played
repeatedly, the previous note will be halted before the new note is
begun, so that the notes will not overlap. Normally you will leave
this unchecked.
Excl Group (Exclusive Group)
001–127: This allows you to assign keys to any of 127 groups.
Keys assigned to the same group will be treated as a single group,
and will be played monophonically with last-note priority. For
example you might assign closed and open hi-hat sounds to the
same group so that two or more hi-hat sounds can not sound
simultaneously.
Off: Keys will not be grouped. This is the default setting.
Inst Type (Instrument Type)
This specifies the type of drum instrument that's assigned to each
key. The instruments that can be selected for each Tone Group of
the step sequencer will depend on the type that you specify here.
For example if this is set to Kick, you'll be able to select from the
step sequencer's Tone Group "Kick." If this is set to Snare, you'll
be able to select from the Tone Group "Snare1" and "Snare2."
Note-On (Enable Note-On Receive)
On (checked): Note-on messages will be received. Normally you
will check this, but you can uncheck it if you do not want specific
notes to sound.
Note-Off (Enable Note-Off Receive)
On (checked): Note-off messages will be received. Normally you
will uncheck this. This is effective if Hold (P–BASIC> NOTE-
ON) is ON. In the case of a drum program, you will normally
select Hold On. In this case if Enable Note Off Receive is
checked, note-off messages will be received, and the sound will
stop (the release segment of the EG will begin) when the key is
released.
MIXER
In Program mode, Drum kits will sound using the settings of
the selected program. Pan is valid if D-KIT SET (P–AMP>
BASIC) is checked. Bus Select, FX Control Bus, and Send
1/2 are valid if D-KIT SET (P–FX ROUTING> BUS) is
checked. Be aware that while editing a drum kit, the edited
results will not be reflected unless these settings have been
made.
Pan
Specifies the panning for each key.
[00(INT)...47(USER)]
[C–1...G9]
[Off, On]
[Off, On]
[Off, 001...127]
[Kick...SFX]
[Off, On]
[Off, On]
[Rndm, L001...C064...R127]
L001 places the sound at far left, and R127 places the signal at far
right. With a setting of Rndm (Random), the drum sample will be
panned randomly at each note-on.
Bus Select
For each key, specify the bus where the sound will be sent.
For example, you might send Snare sounds to IFX1 and Kick
sounds to IFX2 to apply separate insert effects, and send the
remaining sounds to L/R without applying insert effects.
Tip: In most of the preloaded drum kits, the following types of
drum instrument have the same Bus Select settings.
Snares → IFX1
Kicks → IFX2
Cymbals → IFX3
Toms, percussions, others→ IFX4
FX Control Bus
For each key, you can select whether the signal will be sent to FX
Control bus (stereo two-channel) FX Ctrl1 or 2.
Normally you will leave this off, but you can use this setting if you
want to control an effect by playing a specific key.
You can use this with the following effects:
Vocoders:
D09: Vocoder
Compressor and gate-type effects:
S03: Stereo Limiter
S06: Stereo Gate
For examples of how to use this, see page 209.
Send1 (to MFX1)
Send2 (to MFX2)
For each key, specify the send levels to master effects 1 and 2.
These settings are valid when Bus Select is set to L/R or Off. If
Bus Select is set to IFX1–5, the send level to master effects 1 and
2 will be determined by the Program, Combination, or Sequencer
mode P8: Routing/IFX–Insert FX Setup page parameters Send1
and Send2 which are located after the sound passes through IFX1–
5.
5–1...5: FUNCTION
V
• 0: Write Drum Kits see page 180
• 1: Rename Drum Kit see page 180
• 2: Copy Drum Kit see page 180
• 3: Copy Key Setup see page 180
• 4: Swap Key Setup see page 181
For more information, please see the "Global, Media:
FUNCTION" section on page 176.
5: DRUM KIT 5–5: VOICE
[L/R, IFX 1...5, Off]
[Off, FC1, FC2]
[000...127]
[000...127]
173