Sequencer mode
FF/REW Speed
This allows you to set the speed to fast-forward or rewind.
To fast-forward or rewind, hold down the SEQUENCER
(START/STOP) button and press the cursor button (fast-
forward) or (rewind).
1. In Speed, specify the speed (relative to the playback tempo)
where fast-forward and rewind will occur.
The Speed setting is in multiples of the playback tempo. A setting
of 1 is the same speed as the playback tempo. Settings of 2–4
respectively correspond to double, triple, or quadruple speed of the
playback tempo.
Note: Fast-forward and rewind speeds may be slower in regions
with dense performance data. Fast-forward and rewind speeds will
differ between regions where the performance data is dense or
sparse.
2. If Ignore Tempo is checked, the playback tempo and note
length will be ignored, and fast-forward and rewind occurs.
If this item is unchecked, fast-forward and rewind will be
performed at the speed you specify for Speed.
Set Location
(Set Location for Locate Key)
Here you can specify the playback start location that you will
access when you execute the Locate operation.
To move to the specified location, hold down the EXIT(
button and press the SEQUENCER
From the left, these values are the Measure (001-999), Beat (01-
16), and Clock Tick (000-479).
For example if you specify 001:01.000 and then execute the
Locate operation, you'll move to the beginning of the song.
If you press the PAGE- (CLEAR) button, the Set Location value is
set to 001:01.000.
By pressing the PAGE+ (CAPTURE) button, you can specify the
current playback location as the Set Location value.
Detune BPM Adjust
Detune BPM Adjust is available on the Pitch tab of Track Param
page.
When the program selected for a track uses a phrase, or rhythm
loop multisample, you can use this command to change the BPM
of the phrase or rhythm. The BPM can be adjusted by modifying
the pitch. This command is available when the Detune setting of
that track is selected. When you execute this command, the
selected Detune value will be adjusted.
For more information, please see the "Detune BPM Adjust" sec-
tion on page 95.
142
)
(REC) button (
).
Link From Measure current location
Link From Mesure current location is available on S–TRACK
EDIT page.
If this check box is selected, the From Measure setting will be
linked to the current location, and the location of the displayed
track will also change. The location will change to follow this even
during playback or recording.
Set Song Length
Set Song Length is available on S–TRACK EDIT page.
This command changes the length of the specified song.
1. In Length, specify the length of the song.
All data following the measure specified by Length will be
deleted.
Erase Track
Erase Track is available on S–TRACK EDIT page.
This command erases the data from the specified track.
1. In Track Select, select the track that you wish to erase.
2. Select "Erase Track" to open the dialog box.
3. Select the track containing the data you want to erase.
If you don't check All Tracks, the data will be erased only from
the tracks you specify in Track Select.
If you check All Tracks, the musical data of all tracks will be
erased.