System Exclusive Events Supported In Sequencer Mode - Korg KROSS Parameter Manual

Sequencer mode

System Exclusive events supported in Sequencer mode

You can record and play back System Exclusive events, and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in real-time:
• Exclusive messages received from an external MIDI device
• Parameter changes in Sequencer mode (see table below)
• Master Volume universal exclusive messages assigned to the foot pedal
Parameter change messages that you can realtime-record in Sequencer mode
Front panel/Page
ARP
Front panel
DRUM TRACK
PROG, MIX
SEQ
ARP
S–INPUT/CTRL CONTROLLERS
S–LOOP/TONE TONE ADJ, TONE EG
OSC
S–TRACK PITCH
SCALE
S–ZONE/DELAY DELAY
ASSIGN
S–ARP A, B
SCAN ZONE
PATTERN, CHANNEL
S–DRUM TRACK
S–STEP SEQ BASIC, EDIT, INST, MOD
BUS, SEND
Insert FX Setup
S–IFX
IFX 1–5
Common FX LFO
SETUP
S–MFX
MFX 1/2
*1: Solo On/Off is always controlled by events in the track, regardless of the play/mute status of that track.
The maximum amount of exclusive data that can be recorded at once is approximately 320 Kbytes. This size will decrease if other
events exist within the same measure.
You cannot simultaneously record exclusive messages received from an external MIDI device and parameter changes produced by
editing.
The events that will be recorded are controlled by the G–MIDI> OUT settings SEQ Mode Param. MIDI Out. For Control Change, only
control change messages will be recorded. For SysEX-Param Change, only parameter changes and exclusive messages will be recorded
(see "Param. MIDI Out" on page 162).
Realtime recording will not record parameter edits that you perform by executing functions in the various pages, nor changes you make
by using the Effect Preset function to recall effect parameters.
152
ARP button
DRUM TRACK button
Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off
[GATE], [VELOCITY], [SWING]
All "SW1," "SW2" parameters
All "Tone Adjust", "EG Adjust" parameters
Force OSC Mode, OSC Select, Portamento
Transpose, Detune, Bend Range
Use Program's scale, Type, key, Random
Delay Time [ms], MIDI/Tempo Sync., Base Note, Times
All parameters
All parameters
All parameters
All "Drum Track" parameters
All step sequencer parameters other than STEP, ZONE, and STATUS (RUN/STOP).
Bus Select, Send1, Send2, Fx Control Bus
IFX, Effect On/Off, Chain to, Chain, Pan, Bus Sel, FX Control Bus, Send1, Send2
All effect parameters
All "Common FX LFO 1, 2" parameters
MFX, Effect On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2
All effect parameters
Parameter
*1