Pitch - Korg KROSS Parameter Manual

transmitted. If this is 001–127, a CC#65 of 127 and CC#05 of 1–
127 will be transmitted.
If this is set to PRG, nothing will be transmitted.
This data is transmitted and received on the MIDI channel
specified for each track by MIDI Channel (S–TRACK> MIDI).
(See G–MIDI> OUT: SEQ Mode "Track MIDI Out" on page 162)
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
Note: If this is disabled because of the setting of another
parameter, "–" is shown.
3: S–TRACK (Track Parameters) 3–3: PITCH
3–3: PITCH
Here you can make pitch-related settings for each MIDI track.
Track 01...16 (Track Number)
To select a track, place the cursor at one of the following
parameters, and use the cursor buttons   to switch tracks. (see
page 105)
Transpose
Adjusts the pitch of each MIDI track in semitone steps.
12 units equal one octave.
Detune (Use BPM Adj.)
Adjusts the pitch of each MIDI track in one-cent units.
+0000: Normal pitch.
Note: You can also use the Detune BPM Adjust function (see
page 96) to automatically make a detune setting from a calculation
in BPM units.
Transpose and Detune do not affect the notes transmitted via
MIDI Out. Transpose and Detune can be controlled via
MIDI RPN messages received on the Track's MIDI channel.
The way that this works depends on whether or not the Track
uses a Drum Program.
If the Track does not use a Drum Program for example, if it
uses a Single or Double Program then MIDI RPN Coarse
Tune will control Transpose, and RPN Fine Tune will
control Detune.
If the Track uses a Drum Program, MIDI RPN Coarse Tune
and Fine Tune will be combined to control Detune. The
overall range is ±1 octave for coarse tune and fine tune
together.
Bend Range
Specifies the amount of pitch change that will occur when the
pitch bender is used, in semitone units.
PRG: The pitch range specified by the program will be used.
–24...+24: This setting will be used regardless of the setting in the
program.
As long as this is set to something other than PRG, you can
control the Bend Range using MIDI RPN Pitch Bend
Change messages.
Track Info.
Shows the settings of tracks 1–16 for the parameter that you're
editing.
If this is disabled because of the setting of another parameter, "–"
is shown.
[–60...+00...+60]
[–1200...+0000... +1200]
[PRG, –24...+00...+24]
117