Pad Audio Play:function - Korg KROSS Parameter Manual

song cannot be assigned to multiple pads. These settings are
shared with the AUDIO RECORDER SETUP window. These
settings are saved to the SD card when you switch to a different
audio song or when you turn off the power. If you remove the SD
card immediately after making the settings, the settings are not
saved.
A
B
These specify the points at which playback starts (point A) and
stops (point B) repeating when Loop is on. From the left, this
shows hours, minutes, and seconds. Set the loop start location
(point A) and end location (point B) to specify the loop region.
Note: Point A and point B will be at least three seconds apart.
TIP: If you move the cursor to A or B, and press the ENTER
button during playback, the current time is specified as the point.
When you use this method to specify the time location of a point,
the exact location is specified with an accuracy that is more precise
than one-second units.
FUNCTION
V
• 0: Rename Audio Song see page 200
• 1: Delete Audio Song see page 200
• 2: Set Play Level see page 200
• 3: Adjust Audio Level see page 200
Pad Audio Play:FUNCTION Copy Audio Song Setting

Pad Audio Play:FUNCTION

Procedure for each function
1. Press the FUNCTION button to open the function list.
2. Adjust settings in the dialog box.
[0:00:00...2:59:56]
For details on the settings in each dialog box, refer to the
explanation of each function.
[0:00:03...2:59:59]
Press the OK button to execute, or press the Cancel button if
you decide not to execute.
AUDIO PLAY SETUP window
Copy Audio Song Setting
This function copies the settings of the selected pad. The copied
settings can be used with the Insert or Paste functions.
Paste Audio Song Setting
When you execute this function, the pad audio play settings copied
by Copy Audio Song Setting are pasted to the selected pad. If the
selected pad is not Empty, the settings will be overwritten.
Insert Audio Song Setting
When you execute this function, the pad audio play settings copied
by Copy Audio Song Setting are inserted between a pad and the
pad of the adjacent number.
Note: Sampler settings of the pads following the insert location are
pushed back by one pad, and if there is an Empty pad between
them, it will be filled.
Note: If the bank contains no Empty pad following the insert
location, it is not possible to insert the copy. Use the Delete
Sample function to create an empty space, and then execute this
function again.
Delete Audio Song Setting
This function deletes the audio play settings of the selected pad,
putting it in a state in which no song is assigned. The indication
changes to Empty.
If you execute this function with All Settings in Current Bank
turned on, the same operation is performed for all pads in the
currently loaded bank.
199