St. Analog Record (Stereo Analog Record) - Korg KROSS Parameter Manual

Pre LPF
If a sampler with a very low sampling frequency receives very
high-pitched sound that could not be heard during playback, it
could generate pitch noise that is unrelated to the original sound.
Set "Pre LPF" to On to prevent this noise from being generated.
If you set the "Sampling Fre" to about 3 kHz and set "Pre LPF" to
Off, you can create a sound like a ring modulator.
Resolution [bit]
Output Level
If you set a smaller value for the "Resolution" parameter, the
sound may be distorted. The volume level may also be changed.
Use "Output Level" to adjust the level.
Single size effects 017: Talking Modulator
019: St. Analog Record (Stereo
Analog Record)
This effect simulates the noise caused by scratches and dust on
analog records. It also reproduces some of the modulation caused
by a warped turntable.
Stereo In - Stereo Out
Left
EQ Trim Pre EQ
EQ Trim
Pre EQ
Right
Paramter Value
Spd/RPM Speed 33 1/3, 45, 78
←
Flutter 0...100
Noise
Noise Dens 0...100
Density
←
Noise Tone 0...100
NoiseLevel Noise Level 0...100
Src Source Off...Tempo
Amt Amount –100...+100
ClickLevel Click Level 0...100
Src Source Off...Tempo
Amt Amount –100...+100
EQ Trim Pre EQ Trim 0...100
Pre EQ Cutoff
PEQ F[Hz] 300...10.00k
[Hz]
←
Q 0.5...10.0
←
Gain [dB] –18.0...+18.0 Sets the EQ gain
Dry, 1 : 99...
←
Wet/Dry
99 : 1, Wet
Src Source Off...Tempo
Amt Amount –100...+100
Flutter
This parameter enables you to set the depth of the modulation
caused by a warped turntable.
Click Level
This parameter enables you to set the level of the click noise that
occurs once every rotation of the turntable. This simulation
reproduces record noise, and the noise generated after the music
on a vinyl record finishes.
Wet / Dry
Analog Record
Simulation
Wet / Dry
Explanation
Sets the r.p.m. of a
record
Sets the modulation
depth p.229
Sets the noise density
Sets the noise tone
Sets the noise level
Selects the
modulation source
for the noise level
Sets the modulation
amount of the noise
level
Sets the click noise
level p.229
Selects the modulation
source for the click
noise level
Sets the modulation
amount of the click
noise level
Sets the EQ input
level
Sets the EQ center
frequency
Sets the EQ band
width
Sets the balance
between the effect
and the dry input
Selects a modulation
source for Wet/Dry
Sets the modulation
amount for Wet/Dry
l
229