P–Ams Mixer - Korg KROSS Parameter Manual

Center ramp to +Inf or –Inf, the Bottom-Low ramp will be grayed
out.
11–4: KT.2 (Common Keyboard Track 2)
Here you can adjust settings for the second common keyboard
track.
For more information, please see the "11–3: KT.1(Common
Keyboard Track 1)" section on page 44.
11–1...4: FUNCTION
V
• 0: Write Program, Write/Initialize Program
• 1: Solo Setting see page 63
• 2: Compare see page 64
• 3: Auto Song Setup see page 64
• 4: Add to Favorite see page 64
For more information, please see the "Program: Function" section
on page 63.
12: P–AMS MIXER 11–4: KT.2 (Common Keyboard Track 2)
12: P–AMS MIXER
Each Oscillator has two AMS Mixers, which are simple but
powerful tools for combining and modifying AMS signals.
The two Oscillators also share two Common keyboard tracking
generators, in addition to the dedicated keyboard tracking for the
Filter and Amp.
These pages let you control all of these modulation sources.
Note that when the Oscillator Mode is set to Single, only
Oscillator 1's AMS Mixers are active; the pages for Oscillator 2
will be grayed out.
see page 63
12–1: 1 (AMS Mixer1)
The AMS Mixers combine two AMS sources into one, or process
an AMS source to make it into something new.
For instance, they can add two AMS sources together, or use one
AMS source to scale the amount of another. You can also use them
to change the shapes of LFOs and EGs in various ways, modify the
response of realtime controllers, and more.
You can select the output of the AMS mixers as an AMS source in
the same way as an LFO.
This also means that the original, unmodified inputs to the AMS
Mixers are still available as well. For instance, if you use LFO1 as
an input to an AMS Mixer, you can use the processed version of
the LFO to control one AMS destination, and the original version
to control another.
Finally, you can cascade the two AMS Mixers together, by using
AMS Mixer 1 as an input to AMS Mixer 2.
OSC (Oscillator Select)
Select the oscillator (1 or 2) that you want to edit.
Note: Oscillator 2 can be selected if Oscillator Mode is set to
Double.
Type (Mixer Type)
This controls the type of processing performed by AMS Mixer 1.
Each of the Mixer Types is discussed in detail over the next several
pages.
A+B adds two AMS sources together. For more information,
please see the "A+B" section on page 46.
Amt Ax B scales the amount of one AMS source with the other.
For more information, please see the "Amt AxB" section on
page 46.
Offset adds or subtracts a constant value to or from an AMS
source. For more information, please see the "Offset" section on
page 47.
Smoothing specifies the smoothness of movement between two
values. You can use this to smooth sudden changes such as an
abrupt movement of the modulation wheel or sharp angle of the
LFO. For more information, please see the "Smoothing" section
on page 47.
Shape adds curvature to the AMS input. For more information,
please see the "Shape" section on page 47.
Quantize turns smooth transitions into discrete steps. For more
information, please see the "Quantize" section on page 48.
[A+B, Amt AxB, Offset, Smoothing, Shape,
Quantize, Gate Control]
[1, 2]
45