Hitachi VSP F1500 User And Reference Manual page 388

Table 9-36 SSB codes returned by raidcom modify ldev -status enable_fullallocation/
raidcom modify ldev -status enable_fullallocation/disable_fullallocation
Executing/
Error message
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
Get Command Async
Status
Get Command Async
Status
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
9-64
disable_fullallocation
Error code
Async
SSB1 SSB2
2E00 0000
2E00 002F
2E00 0030
2E10 0065
2E10 600B
2E10 600D
2E10 601B
2E10 8000
2E11 001B
2E20 0000
2E30 000B
2E30 0099
2E30 0206
2E30 0209
2EE8 00EE
2EE8 FEEC
2EF3 9F02
Troubleshooting
Command Control Interface User and Reference Guide
Description
The LDEV number is out of settable range.
The specified value of the Full Allocation is invalid.
Full Allocation cannot be specified to the specified
LDEV because the emulation type is not supported.
The operation failed because the specified LDEV is
a DP-VOL that belongs to the pool of which
accelerated compression is enabled.
The associated pool is blocked.
The operation cannot be performed because a pool
volume is being deleted.
The free space in the specified pool is insufficient.
The operation cannot be performed because
Storage Navigator or Device Manager - Storage
Navigator is in progress, another application is in
progress on the SVP, or the configuration is being
changed. Wait a while, and then retry the
operation.
The specified LDEV is blocked.
LDEV is not installed.
The specified LDEV is not DP-VOL.
The specified LDEV is a volume of which Data
Direct Mapping attribute is enabled.
The operation cannot be performed because the
specified LDEV is a deduplication system data
volume.
The operation cannot be performed because the
specified LDEV is a volume for which the capacity
saving setting is enabled.
The command cannot be accepted because the
DKC is busy. After a while, execute the same
command.
An internal error occurred.
The specified operation cannot be performed
because it is not supported.