Hitachi VSP F1500 User And Reference Manual page 361

Executing/
Error message
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
CMDRJE Executing
raidcom modify port -topology
Error code
Async
SSB1 SSB2
B955 040F
B955 044C
B955 054E
B955 05A6
B955 05A7
B955 060F
B955 06C0
B955 06C1
B955 06C2
B955 1039
B955 104F
B955 113D
B955 113F
B955 11A5
B955 12AF
B980 B901
B980 B902
Troubleshooting
Command Control Interface User and Reference Guide
Description
An internal error occurred.
The specified AL-PA is invalid.
The specified topology is invalid.
The other than "fabric on" cannot be specified
when specifying a topology of the package for
Fibre Channel over Ethernet.
The other than "P-to-P (point to point)" cannot be
specified when specifying a topology of the
package for Fibre Channel over Ethernet.
The specified LDEV is not installed.
The specified LDEV is being used as a volume of a
GAD pair.
The specified LDEV is used as a quorum disk.
The specified LDEV is used for a TrueCopy pair or a
Universal Replicator pair.
The command device being used at the local CCI
exists under the port.
The program product is not installed.
Invalid host speed is set for the 4Gbps fibre
adapter. The available host speeds are AUTO, 1G,
2G, and 4G only.
Invalid host speed is set for the 8Gbps fibre
adapter. The available host speeds are AUTO, 2G,
4G, and 8G only.
The other than "10G" cannot be specified when
specifying a host speed of the package for Fibre
Channel over Ethernet.
The combination of the specified topology FC-AL
and the host speed set for the fibre channel
adapter is not supported. See the Provisioning
Guide of your system for supported combinations
of data transfer speed and type of connection.
The command was rejected because the specified
port is for NAS Platform (System LU).
The command was rejected because the selected
port is for NAS Platform (User LU).
9-37