Hitachi VSP F1500 User And Reference Manual page 153

:[2] set a user account to this service.
:[3] confirm to start using horcmstart 0.
:[4] confirm to stop using horcmshutdown 0.
:[5] start as a service by net start HORCM0.
Starting CCI as a service
1 Registering the CCI (HORCM) instance as a service. The system
.
administrator must add the CCI instance using the following command:
C:\HORCM\tool\>svcexe /S=HORCM0 "/A=C:\HORCM\tool
\svcexe.exe"
2 Customizing a sample script file. The system administrator must
.
customize the sample script file (HORCM0_run.txt) according to the CCI
instance. For details, see the descriptions in the HORCM0_run.txt file.
3 Setting the user account. The system administrator must set the user
.
account for the CCI administrator as needed.
When using the GUI, use "Administrative Tools - Services - Select
HORCM0 - Logon".
When using the CUI, use "sc config" command as follows:
C:\HORCM\tool\>sc config HORCM0 obj= AccountName password=
password
If the system administrator uses the default account (LocalSystem), add
"HORCM_EVERYCLI=1":
# **** For INSTANCE# X, change to HORCMINST=X as needed
START:
set HORCM_EVERYCLI=1
set HORCMINST=0
set HORCC_LOG=STDERROUT
C:\HORCM\etc\horcmstart.exe
exit 0
4 Starting the CCI instance from the service. After you have confirmed
.
starting and stopping using "horcmstart 0" and "horcmshutdown 0", you
must verify that HORCM0 starts from the service and that HORCM0
started automatically from REBOOT, using the following command:
C:\HORCM\tool\>net start HORCM0
5 Stopping CCI instance as a service. Instead of using the "horcmshutdown
.
0" command, you must use the following command to stop HORCM0:
C:\HORCM\tool\>net stop HORCM0
(By using the "horcmshutdown 0" command, the script written into
HORCM0_run.txt will automatically restart HORCM0).
Command Control Interface User and Reference Guide
Starting up CCI
****
4-7