Hitachi VSP F1500 User And Reference Manual page 334

Error Error
code message
EX_ENOR No
MT remote
host alive
for
remote
command
s or
remote
HORCM
might be
blocked
(sleeping)
on an
existing
I/O
EX_INVM Invalid
OD RAID
command
mode
EX_INVC Invalid
MD RAID
command
EX_ENOG No such
RP group
EX_UNW Unknown
COD function
code
EX_CMDI Control
OE command
I/O error
EX_CMDR An order
JE to the
control/
command
device
was
rejected
9-10
Condition
A timeout occurred on
remote communication, and
HORC Manager failed to re-
execute.
Detected a contradiction for
a command.
Detected a contradiction for
a command.
The designated device or
group name does not exist in
the configuration definition
file, or the network address
for remote communication
does not exist.
Detected a contradiction for
a command.
A read/write to the
command device failed with
an I/O error.
The request to the command
device failed or was rejected.
Note: This error code is
sometimes caused by the
operating system and
reported as EX_CMDIOE
instead of EX_CMDRJE (see
next row).
Troubleshooting
Command Control Interface User and Reference Guide
Recommended action
Please confirm that the HORC Manager
in the remote host is running. If the IP
address of the host has been changed,
restart the HORCM instance. If the
HORCM still does not restart, increase
the value of the timeout in the
configuration definition file.
Contact Hitachi Data Systems customer
support.
Contact Hitachi Data Systems customer
support.
Verify the device or group name and
add it to the configuration definition file
of the remote and local hosts.
Retry your operation after restart of the
instance for CCI. Contact Hitachi Data
Systems customer support if the
operation fails because of same error
again.
Refer to the host syslog file, and
investigate the cause of the error.
If the problem persists, collect the log
information of HORCM ($HORCM_LOG),
and contact Hitachi Data Systems
customer support.
Verify the program products, such as
TrueCopy and ShadowImage, are
installed.
Verify ports are set.
Verify CU paths have been established
by Device Manager - Storage Navigator,
CCI, or other methods.
Verify that the target volume is
available.
CCI displays "SSB" in the output of the
commands so a service representative
Returne
d Value
242
241
240
239
238
237
221