System Buffer Flushing Function - Hitachi VSP F1500 User And Reference Manual

raidscan -pi $Volume{bf48a395-0ef6-11d5-8d69-00c00d003b1e} -find
DEVICE_FILE
PRODUCT_ID
\Vol46\Dsk1
OPEN-3

System buffer flushing function

The logical drive to be flushed can be specified by the following two methods.
One method is that the logical drive (for example, G:\hd1 drive, as below) is
specified immediately, but this method must know about the logical drive
corresponding to a group before executing the sync command. Also the
volume is mounting by a directory and this method requires finding its
volume name. To solve such a complication, CCI supports a method that
flushes the system buffer associated with a logical drive through finding a
volume{guid} corresponding to a group of the configuration file. This method
does not depend on mounted point, so that it is possible to flush the volume
mounted by a directory. This method is supported to be specified a group to
the raidscan -find sync command.
The following example flushes the system buffer associated with the ORB
group through $Volume.
raidscan -pi $Volume -find sync -g ORB
[SYNC] : ORB ORB_000[-] -> \Dmt1\Dsk1 : Volume{bf48a395-0ef6-11d5
8d69-00c00d003b1e}
[SYNC] : ORB ORB_001[-] -> \Dmt1\Dsk2 : Volume{bf48a395-0ef6-11d5
8d69-00c00d003b1e}
[SYNC] : ORB ORB_002[-] -> \Dmt1\Dsk3 : Volume{bf48a395-0ef6-11d5
8d69-00c00d003b1e}
8-6
UID S/F PORT
0
Figure 8-3 LDM volume flushing
Examples of using CCI commands
Command Control Interface User and Reference Guide
TARG LUN
F CL2-K 7
SERIAL LDEV
1 61456 193