Volume - Hitachi VSP F1500 User And Reference Manual

# raidcom get ldev -ldev_id 200
While the delete LDEV operation is in process, the VOL_TYPE is
REMOVING. When the volume is deleted correctly, the VOL_TYPE changes
from REMOVING to NOT DEFINED.
If VOL_TYPE is other than REMOVING or NOT DEFINED, the deletion
ended abnormally. Check CSV_Status to take either of the following
actions:
¢
¢
Deleting a virtual volume by blocking, initializing, and then deleting the volume
Use the following procedure to delete a virtual volume by blocking,
initializing, and then deleting the volume. The command examples in this
procedure use LDEV number 200 for the virtual volume being deleted.
1 Block the volume by executing the raidcom modify ldev command.
.
# raidcom modify ldev -status blk –ldev_id 200
2 Verify that the block LDEV command completed normally by executing the
.
raidcom get command_status command. If the command completed
normally, the value "0" is returned.
# raidcom get command_status
3 Initialize the volume by executing the raidcom initialize ldev
.
command.
# raidcom initialize ldev -operation fmt -ldev_id 200
4 Verify that the initialize LDEV command completed normally by executing
.
the raidcom get command_status command. If the command completed
normally, the value "0" is returned.
# raidcom get command_status
5 Check the status of the volume by executing the raidcom get ldev
.
command.
# raidcom get ldev -ldev_id 200
When the volume is initialized correctly, the VOL_TYPE is OPEN-V-CVS
and the CSV_Status is DISABLED.
6 Delete the volume by executing the raidcom delete ldev command.
.
# raidcom delete ldev -ldev_id 200
7 Verify that the delete LDEV command completed normally by executing
.
the raidcom get command_status command. If the command completed
normally, the value "0" is returned.
# raidcom get command_status
5-32
When CSV_Status shows FAILED, see the Troubleshooting Dynamic
Provisioning section in the Provisioning Guide for your system.
When CSV_Status shows a status other than FAILED or does not show
any status, execute the raidcom delete ldev command again without
specifying the -operation initialize_capacity_saving option.
Provisioning operations with CCI
Command Control Interface User and Reference Guide