Ipv6 Mce Configuration Example - HP FlexNetwork HSR6600 Configuration Manual

IPv6 MCE configuration example

Network requirements
As shown in
different VPNs and advertise the VPN routes to PE 1 through OSPFv3.
Figure 139 Network diagram
VPN 1
2012:1::/64
2012:1::2/64
Configuration procedure
Assume that the system name of the MCE device is MCE, the system names of the edge routers of
VPN 1 and VPN 2 are VR1 and VR2, and the system name of PE 1 is PE1.
1. Configure VPN instances on the MCE and PE 1:
# On MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for
each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
Figure 139, VPN 2 runs RIPng. Configure the MCE device to separate routes from
GE1/1/3.1
2001:2::3/64
GE1/1/2
2001:1::2/64
GE1/1/1
GE1/1/1
2001:1::1/64
VR 1
2002:1::2/64
2012::2/64
PE 1
GE1/1/1.1
2001:2::4/64
GE1/1/1.2
2002:2::4/64
MCE
GE1/1/3.2
2002:2::3/64
GE1/1/2
2002:1::1/64
GE1/1/2
VR 2
GE1/1/1
VPN 2
2012::/64
538
VPN 2
Site 1
CE
PE 2
PE 3
CE
VPN 1
Site 2