HP FlexNetwork HSR6600 Configuration Manual page 153
Comware 7 mpls
Hide thumbs
Also See for FlexNetwork HSR6600:
- Command reference manual (542 pages) ,
- Troubleshooting manual (41 pages) ,
- Security configuration manual (559 pages)
Table of Contents
Advertisement
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
5.
Configure a bypass tunnel on Router B (the PLR):
# Configure an explicit path for the bypass tunnel.
[RouterB] explicit-path by-path
[RouterB-explicit-path-by-path] nexthop 3.2.1.2
[RouterB-explicit-path-by-path] nexthop 3.3.1.2
[RouterB-explicit-path-by-path] nexthop 3.3.3.3
[RouterB-explicit-path-by-path] quit
# Create MPLS TE tunnel interface Tunnel 5 for the bypass tunnel.
[RouterB] interface tunnel 5 mode mpls-te
[RouterB-Tunnel5] ip address 11.1.1.1 255.255.255.0
# Specify the tunnel destination address as LSR ID of Router C.
[RouterB-Tunnel5] destination 3.3.3.3
# Specify the tunnel signaling protocol as RSVP-TE.
[RouterB-Tunnel5] mpls te signaling rsvp-te
# Specify the explicit path to be used as by-path.
[RouterB-Tunnel5] mpls te path preference 1 explicit-path by-path
# Set the bandwidth that the bypass tunnel can protect.
[RouterB-Tunnel5] mpls te backup bandwidth un-limited
[RouterB-Tunnel5] quit
# Bind the bypass tunnel to the protected interface.
[RouterB] interface gigabitethernet 1/1/2
[RouterB-GigabitEthernet1/1/2] mpls te fast-reroute bypass-tunnel tunnel 5
[RouterB-GigabitEthernet1/1/2] quit
# Execute the display interface tunnel command on Router B. The output shows that the
tunnel interface Tunnel 5 is up. (Details not shown.)
6.
Configure a static route on Router A to direct the traffic destined for subnet 100.1.2.0/24 to
MPLS TE tunnel 4.
[RouterA] ip route-static 100.1.2.0 24 tunnel 4 preference 1
Verifying the configuration
# Display LSP entries on each router to verify that Router B and Router C each have two CRLSPs
and the bypass tunnel backs up the primary CRLSP.
[RouterA] display mpls lsp
FEC
1.1.1.1/4/48960
2.1.1.2
: Enabled
Record Label
: Enabled
Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No
Auto Created
: Disabled
: 10
Retry Interval
: Disabled
Reoptimization Freq
: None
Backup LSP ID
: Disabled
Auto Bandwidth Freq
: -
Max Bandwidth
: -
Proto
In/Out Label
RSVP
-/1245
Local
-/-
143
: Enabled
: No
: 2 sec
: -
: -
: -
: -
Interface/Out NHLFE
GE1/1/1
GE1/1/1
Advertisement
Table of Contents
