HP FlexNetwork HSR6600 Configuration Manual page 393

Interface : InLoop0
Destination: 10:2::/96
NextHop : ::
Interface : GE1/1/1
Destination: 10:2::1/128
NextHop : ::1
Interface : InLoop0
Destination: 100::/96
NextHop : ::FFFF:10.1.1.1
Interface : GE1/1/2
Destination: 200::/96
NextHop : 10:2::2
Interface : GE1/1/1
Destination: FE80::/10
NextHop : ::
Interface : NULL0
Destination: FF00::/8
NextHop : ::
Interface : NULL0
# Enable BGP update packet debugging on PE 2. The output shows that PE 2 has advertised
the route for 100::/96, and the AS_PATH is 100 600.
<PE2> terminal monitor
<PE2> terminal logging level 7
<PE2> debugging bgp update vpn-instance vpn1 10:2::2 ipv6
<PE2> refresh bgp all export ipv6 vpn-instance vpn1
*Jun 13 16:12:52:096 2012 PE2 BGP/7/DEBUG: -MDC=1;
BGP_IPV6.vpn1: Send UPDATE to update-group 0 for following destinations:
Origin
AS path
Next hop
100::/96,
*Jun 13 16:12:53:024 2012 PE2 BGP/7/DEBUG: -MDC=1;
BGP.vpn1: Send UPDATE MSG to peer 10:2::2(IPv6-UNC) NextHop: 10:2::1.
# Execute the display bgp routing-table ipv6 peer received-routes command on CE 2 to
verify that CE 2 has not received the route to 100::/96.
<CE2> display bgp routing-table ipv6 peer 10:2::1 received-routes
Total number of routes: 0
2. Configure BGP AS number substitution:
# Configure BGP AS number substitution on PE 1.
: Incomplete
: 100 600
: ::FFFF:10.1.1.1
383
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0