HP FlexNetwork HSR6600 Configuration Manual page 266

Figure 74 Network diagram
Table 16 Interface and IP address assignment
Device
CE 1
PE 1
ASBR-PE1
Configuration procedure
1. Configure IGP on the MPLS backbone.
This example uses OSPF. (Details not shown.)
# Execute the display ospf peer command to verify that each ASBR-PE has established an
OSPF adjacency in Full state with the PE in the same AS, and that PEs and ASBR-PEs in the
same AS have learned the routes to the loopback interfaces of each other. Verify that each
ASBR-PE and the PE in the same AS can ping each other. (Details not shown.)
2. Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs:
# Configure basic MPLS on PE 1, and enable MPLS LDP on the interface connected to
ASBR-PE 1.
<PE1> system-view
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] interface pos 1/1/0
[PE1-Pos1/1/0] mpls enable
[PE1-Pos1/1/0] mpls ldp enable
Interface IP address
GE1/1/1 10.1.1.1/24
Loop0 1.1.1.9/32
GE1/1/1 10.1.1.2/24
POS1/1/0 172.1.1.2/24
Loop0 2.2.2.9/32
POS1/1/0 172.1.1.1/24
POS1/1/1 192.1.1.1/24
Device
CE 2
PE 2
ASBR-PE2
256
Interface IP address
GE1/1/1 10.2.1.1/24
Loop0 4.4.4.9/32
GE1/1/1 10.2.1.2/24
POS1/1/0 162.1.1.2/24
Loop0 3.3.3.9/32
POS1/1/0 162.1.1.1/24
POS1/1/1 192.1.1.2/24