Configuring Ipv6 Mpls L3Vpn Inter-As Option A - HP FlexNetwork HSR6600 Configuration Manual

Comware 7 mpls

Hide thumbs Also See for FlexNetwork HSR6600:

Table of Contents

Configure a GRE tunnel:

# Configure PE 1.

[PE1] interface tunnel 0 mode gre

[PE1-Tunnel0] source loopback 0

[PE1-Tunnel0] destination 2.2.2.9

[PE1-Tunnel0] ip address 20.1.1.1 24

[PE1-Tunnel0] mpls enable

[PE1-Tunnel0] quit

# Configure PE 2.

[PE2] interface tunnel 0 mode gre

[PE2-Tunnel0] source loopback 0

[PE2-Tunnel0] destination 1.1.1.9

[PE2-Tunnel0] ip address 20.1.1.2 24

[PE2-Tunnel0] mpls enable

[PE2-Tunnel0] quit

Verifying the configuration

# Verify that the CEs have learned the route to each other and can ping each other. (Details not

Configuring IPv6 MPLS L3VPN inter-AS option A

Network requirements

CE 1 and CE 2 belong to the same VPN. CE 1 accesses the network through PE 1 in AS 100 and CE

2 accesses the network through PE 2 in AS 200.

Configure IPv6 MPLS L3VPN inter-AS option A, and use VRF-to-VRF method to manage VPN

Run OSPF on the MPLS backbone of each AS.

Figure 92 Network diagram