HP FlexNetwork HSR6600 Configuration Manual page 156

Figure 40 Network diagram
Table 8 Interface and IP address assignment
Device
Router A
Router B
Router D
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address.
(Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each router. Enable BFD
for RSVP-TE on Router B and Router C:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls te
[RouterA-te] quit
Interface IP address
Loop0 1.1.1.1/32
GE1/1/1 2.1.1.1/24
Loop0 2.2.2.2/32
GE1/1/1 2.1.1.2/24
GE1/1/2 3.1.1.1/24
POS1/1/0 3.2.1.1/24
POS1/1/1 3.3.1.1/24
Loop0 4.4.4.4/32
GE1/1/1 4.1.1.2/24
POS1/1/0 4.2.1.2/24
Device Interface
Router E Loop0
POS1/1/0
POS1/1/1
Router C Loop0
GE1/1/1
GE1/1/2
POS1/1/0
Router F Loop0
POS1/1/0
POS1/1/1
146
IP address
5.5.5.5/32
3.2.1.2/24
3.4.1.1/24
3.3.3.3/32
4.1.1.1/24
3.1.1.2/24
3.4.1.2/24
6.6.6.6/32
3.3.1.2/24
4.2.1.1/24