HP FlexNetwork HSR6600 Configuration Manual page 312

<CE4> system-view
[CE4] interface gigabitethernet 1/1/1
[CE4-GigabitEthernet1/1/1] ip address 10.3.1.1 255.255.255.0
[CE4-GigabitEthernet1/1/1] quit
[CE4] bgp 65440
[CE4-bgp-default] peer 10.3.1.2 as-number 100
[CE4-bgp-default] address-family ipv4 unicast
[CE4-bgp-default-ipv4] peer 10.3.1.2 enable
[CE4-bgp-default-ipv4] import-route direct
[CE4-bgp-default-ipv4] quit
[CE4-bgp-default] quit
7. Configure SPE 1:
# Configure basic MPLS and MPLS LDP to establish LDP LSPs.
<SPE1> system-view
[SPE1] interface loopback 0
[SPE1-LoopBack0] ip address 2.2.2.9 32
[SPE1-LoopBack0] quit
[SPE1] mpls lsr-id 2.2.2.9
[SPE1] mpls ldp
[SPE1-ldp] quit
[SPE1] interface gigabitethernet 1/1/1
[SPE1-GigabitEthernet1/1/1] ip address 172.1.1.2 24
[SPE1-GigabitEthernet1/1/1] mpls enable
[SPE1-GigabitEthernet1/1/1] mpls ldp enable
[SPE1-GigabitEthernet1/1/1] quit
[SPE1] interface gigabitethernet 1/1/2
[SPE1-GigabitEthernet1/1/2] ip address 180.1.1.1 24
[SPE1-GigabitEthernet1/1/2] mpls enable
[SPE1-GigabitEthernet1/1/2] mpls ldp enable
[SPE1-GigabitEthernet1/1/2] quit
# Configure the IGP protocol, OSPF, in this example.
[SPE1] ospf
[SPE1-ospf-1] area 0
[SPE1-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0
[SPE1-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] network 180.1.1.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] quit
[SPE1-ospf-1] quit
# Configure VPN instances vpn1 and vpn2.
[SPE1] ip vpn-instance vpn1
[SPE1-vpn-instance-vpn1] route-distinguisher 500:1
[SPE1-vpn-instance-vpn1] vpn-target 100:1 both
[SPE1-vpn-instance-vpn1] quit
[SPE1] ip vpn-instance vpn2
[SPE1-vpn-instance-vpn2] route-distinguisher 700:1
[SPE1-vpn-instance-vpn2] vpn-target 100:2 both
[SPE1-vpn-instance-vpn2] quit
# Establish MP-IBGP peer relationships with SPE 2 and UPE 1, and specify UPE 1 as a UPE.
302