Mpls Te Configuration Examples - HP FlexNetwork HSR6600 Configuration Manual

Comware 7 mpls

Hide thumbs Also See for FlexNetwork HSR6600:

Table of Contents

Display OSPF tunnel interface information.

Reset the automatic bandwidth adjustment

Clear PCC and PCE statistics.

MPLS TE configuration examples

Establishing an MPLS TE tunnel over a static CRLSP

Network requirements

Router A, Router B, and Router C run IS-IS.

Establish an MPLS TE tunnel over a static CRLSP from Router A to Router C to transmit data

between the two IP networks.

The MPLS TE tunnel requires a bandwidth of 2000 kbps. The maximum bandwidth of the link that the

tunnel traverses is 10000 kbps. The maximum reservable bandwidth of the link is 5000 kbps.

Figure 33 Network diagram

Configuration procedure

Configure IP addresses and masks for interfaces. (Details not shown.)

Configure IS-IS to advertise interface addresses, including the loopback interface address:

# Configure Router A.

<RouterA> system-view

[RouterA] isis 1

[RouterA-isis-1] network-entity 00.0005.0000.0000.0001.00

[RouterA-isis-1] quit

[RouterA] interface gigabitethernet 1/1/1

[RouterA-GigabitEthernet1/1/1] isis enable 1

[RouterA-GigabitEthernet1/1/1] quit

[RouterA] interface loopback 0

[RouterA-LoopBack0] isis enable 1

[RouterA-LoopBack0] quit

display ospf [ process-id ] [ area area-id ] mpls te

reset mpls te auto-bandwidth-adjustment timers

reset mpls te pce statistics [ ip-address ]