Ipv6 Pim Snooping Configuration Example - HP A8800 Configuration Manual

Task
Display IPv6 PIM snooping
routing entries.
Display the statistics of IPv6 PIM
messages that IPv6 PIM
snooping obtains.
Clear the statistics of IPv6 PIM
messages that IPv6 PIM
snooping obtains.

IPv6 PIM snooping configuration example

Network requirements
As shown in
sends multicast data to IPv6 multicast group FF2E::101. Receiver 1 belongs to multicast group FF1E::101,
and Receiver 2 belongs to multicast group FF2E::101. Router C and Router D run MLD on their interface
GigabitEthernet 3/1/1. Router A, Router B, Router C, and Router D run IPv6 PIM-SM, and interface
GigabitEthernet 3/1/2 on Router A acts as a C-BSR and C-RP.
Configure MLD snooping and IPv6 PIM snooping on Router E so that Router E forwards IPv6 PIM
messages and multicast data to only the routers that are interested in the multicast data.
Figure 86 Network diagram
Configuration procedure
1. Enable IPv6 forwarding on the devices, configure an IPv6 address and prefix length for each
interface according to
2. On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and configure
interface GigabitEthernet 3/1/2 as a C-BSR and C-RP.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
Command
display pim-snooping ipv6 routing-table [ vlan
vlan-id ] [ slot slot-number ] [ | { begin | exclude
| include } regular-expression ]
display pim-snooping ipv6 statistics [ | { begin
| exclude | include } regular-expression ]
reset pim-snooping ipv6 statistics
Figure 86, Source 1 sends multicast data to IPv6 multicast group FF1E::101, and Source 2
Figure 86. (Details not shown.)
321
Remarks
Available in any view.
Available in any view.
Available in user view.