HP FlexNetwork HSR6600 Configuration Manual page 163

[RouterB] interface gigabitethernet 1/1/1
[RouterB-GigabitEthernet1/1/1] isis enable 1
[RouterB-GigabitEthernet1/1/1] isis circuit-level level-2
[RouterB-GigabitEthernet1/1/1] quit
[RouterB] interface pos 1/1/0
[RouterB-POS1/1/0] isis enable 1
[RouterB-POS1/1/0] isis circuit-level level-2
[RouterB-POS1/1/0] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] isis enable 1
[RouterB-LoopBack0] isis circuit-level level-2
[RouterB-LoopBack0] quit
# Configure Router C.
<RouterC> system-view
[RouterC] isis 1
[RouterC-isis-1] network-entity 00.0005.0000.0000.0003.00
[RouterC-isis-1] quit
[RouterC] interface gigabitethernet 1/1/1
[RouterC-GigabitEthernet1/1/1] isis enable 1
[RouterC-GigabitEthernet1/1/1] isis circuit-level level-2
[RouterC-GigabitEthernet1/1/1] quit
[RouterC] interface pos 1/1/0
[RouterC-POS1/1/0] isis enable 1
[RouterC-POS1/1/0] isis circuit-level level-2
[RouterC-POS1/1/0] quit
[RouterC] interface loopback 0
[RouterC-LoopBack0] isis enable 1
[RouterC-LoopBack0] isis circuit-level level-2
[RouterC-LoopBack0] quit
# Configure Router D.
<RouterD> system-view
[RouterD] isis 1
[RouterD-isis-1] network-entity 00.0005.0000.0000.0004.00
[RouterD-isis-1] quit
[RouterD] interface gigabitethernet 1/1/1
[RouterD-GigabitEthernet1/1/1] isis enable 1
[RouterD-GigabitEthernet1/1/1] isis circuit-level level-2
[RouterD-GigabitEthernet1/1/1] quit
[RouterD] interface loopback 0
[RouterD-LoopBack0] isis enable 1
[RouterD-LoopBack0] isis circuit-level level-2
[RouterD-LoopBack0] quit
# Verify that the routers have learned the routes to one another, including the routes to the
loopback interfaces. This example uses Router A.
[RouterA] display ip routing-table
Destinations : 10
Destination/Mask
1.1.1.9/32
Routes : 10
Proto Pre Cost
Direct 0 0
153
NextHop Interface
127.0.0.1 InLoop0