Task
Display information about the IPv6
FIB of a VPN instance.
Display a VPN instance's FIB
entries that match the specified
destination IPv6 address.
Display information about IPv6
BGP peers established between the
PE and CE in a VPN instance.
Display the BGP VPNv6 routing
information of a VPN instance.
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
IPv6 MCE configuration examples
Using IPv6 ISIS to advertise VPN routes to the PE
Network requirements
As shown in
VPN 2 through VLAN-interface 20. RIPng is used in VPN 2.
Configure the IPv6 MCE to separate routes from different VPNs and advertise VPN routes to PE 1 through
OSPFv3.
Figure
132, the IPv6 MCE device is connected to VPN 1 through VLAN-interface 10 and to
Command
display ipv6 fib vpn-instance
vpn-instance-name [ acl6 acl6-number |
ipv6-prefix ipv6-prefix-name ] [ | { begin |
exclude | include } regular-expression ]
display ipv6 fib vpn-instance
vpn-instance-name ipv6-address
[ prefix-length ] [ | { begin | exclude |
include } regular-expression ]
display bgp vpnv6 vpn-instance
vpn-instance-name peer [ ipv6-address
verbose | verbose ] [ | { begin | exclude |
include } regular-expression ]
display bgp vpnv6 vpn-instance
vpn-instance-name routing-table
[ network-address prefix-length
[ longer-prefixes ] | peer ipv6-address
{ advertised-routes | received-routes } ] [ |
{ begin | exclude | include }
regular-expression ]
428
Remarks
Available in any view
Available in any view
Available in any view
Available in any view