HP FlexNetwork HSR6600 Configuration Manual page 541

Step
3. (Optional.) Configure
the default preference
for IPv6 static routes.
Configuring RIPng between an MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
VPNs to be exchanged between the MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter
RIPng view.
3. Redistribute remote site
routes advertised by the PE.
4. Return to system view.
5. Enter interface view.
6. Enable RIPng on the
interface.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public
network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of
different IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an OSPFv3 process
for a VPN instance and enter
OSPFv3 view.
3. Set the router ID.
Command
ipv6 route-static default-preference
default-preference
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol
[ process-id ] [ allow-ibgp ]
[ allow-direct | cost cost-value |
route-policy route-policy-name ]
*
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
router-id router-id
531
Remarks
The default
preference for IPv6
static routes is 60.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no routes are
redistributed into RIPng.
N/A
N/A
By default, RIPng is disabled.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
common OSPFv3.
Deleting a VPN instance also
deletes all related OSPFv3
processes.
N/A