HP FlexNetwork HSR6600 Configuration Manual page 162

Figure 41 Network diagram
Table 9 Interface and IP address assignment
Device
Router A
Router B
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] network-entity 00.0005.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface gigabitethernet 1/1/1
[RouterA-GigabitEthernet1/1/1] isis enable 1
[RouterA-GigabitEthernet1/1/1] isis circuit-level level-2
[RouterA-GigabitEthernet1/1/1] quit
[RouterA] interface loopback 0
[RouterA-LoopBack0] isis enable 1
[RouterA-LoopBack0] isis circuit-level level-2
[RouterA-LoopBack0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] network-entity 00.0005.0000.0000.0002.00
[RouterB-isis-1] quit
Interface IP address
Loop0 1.1.1.9/32
GE1/1/1 10.1.1.1/24
GE1/1/2 100.1.1.1/24
Loop0 2.2.2.9/32
GE1/1/1 10.1.1.2/24
POS1/1/0 20.1.1.1/24
Device Interface
Router C Loop0
GE1/1/1
POS1/1/0
Router D Loop0
GE1/1/1
GE1/1/2
152
IP address
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24
4.4.4.9/32
30.1.1.2/24
100.1.2.1/24