HP FlexNetwork HSR6600 Configuration Manual page 336

Configuring route related attributes for a VPN instance
Step
1. Enter system view.
2. Enter VPN instance view or
IPv6 VPN view.
3. Configure route targets.
4. Set the maximum number of
active routes.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to the
VPN instance.
Command
system-view
•
Enter VPN instance view:
ip vpn-instance
vpn-instance-name
•
Enter IPv6 VPN view:
a. ip vpn-instance
vpn-instance-name
b. address-family ipv6
vpn-target vpn-target&<1-8>
[ both | export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
326
Remarks
N/A
Configurations made in VPN
instance view apply to both IPv4
VPN and IPv6 VPN.
IPv6 VPN prefers the
configurations in IPv6 VPN view
over the configurations in VPN
instance view.
By default, no route targets are
configured.
By default, the maximum number
of active routes is 1000100.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from storing
too many routes.
A PE supports a maximum of
1000100 active routes.
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
Make sure the routing policy
already exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing) in
this order: LSP tunnel, GRE
tunnel, and CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."