HP FlexNetwork HSR6600 Configuration Manual page 380

[PE3] interface loopback 0
[PE3-LoopBack0] isis enable 2
[PE3-LoopBack0] quit
[PE3] interface pos 1/1/1
[PE3-Pos1/1/1] ip address 10.1.1.1 24
[PE3-Pos1/1/1] isis enable 2
[PE3-Pos1/1/1] mpls enable
[PE3-Pos1/1/1] mpls ldp enable
[PE3-Pos1/1/1] mpls ldp transport-address interface
[PE3-Pos1/1/1] quit
# Configure CE 1.
<CE1> system-view
[CE1] interface loopback 0
[CE1-LoopBack0] ip address 2.2.2.9 32
[CE1-LoopBack0] quit
[CE1] mpls lsr-id 2.2.2.9
[CE1] mpls ldp
[CE1-ldp] quit
[CE1] isis 2
[CE1-isis-2] network-entity 10.0000.0000.0000.0002.00
[CE1-isis-2] quit
[CE1] interface loopback 0
[CE1-LoopBack0] isis enable 2
[CE1-LoopBack0] quit
[CE1] interface pos 1/1/0
[CE1-Pos1/1/0] ip address 10.1.1.2 24
[CE1-Pos1/1/0] isis enable 2
[CE1-Pos1/1/0] mpls enable
[CE1-Pos1/1/0] mpls ldp enable
[CE1-Pos1/1/0] mpls ldp transport-address interface
[CE1-Pos1/1/0] quit
PE 3 and CE 1 can establish an LDP session and IS-IS neighbor relationship between them.
# Configure PE 4 and CE 2 in the same way that PE 3 and CE 1 are configured. (Details not
shown.)
3. Connect the customer carrier and the provider carrier:
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 200:1
[PE1-vpn-instance-vpn1] vpn-target 1:1
[PE1-vpn-instance-vpn1] quit
[PE1] mpls ldp
[PE1-ldp] vpn-instance vpn1
[PE1-ldp-vpn-instance-vpn1] quit
[PE1-ldp] quit
[PE1] isis 2 vpn-instance vpn1
[PE1-isis-2] network-entity 10.0000.0000.0000.0003.00
[PE1-isis-2] address-family ipv4
[PE1-isis-2-ipv4] import-route bgp allow-ibgp
370