Configuring Ipv6 Mpls L3Vpn Inter-As Option C - HP FlexNetwork HSR6600 Configuration Manual

56 bytes from 20::1: icmp_seq=0 hlim=64 time=1.208 ms
56 bytes from 20::1: icmp_seq=1 hlim=64 time=0.867 ms
56 bytes from 20::1: icmp_seq=2 hlim=64 time=0.551 ms
56 bytes from 20::1: icmp_seq=3 hlim=64 time=0.566 ms
56 bytes from 20::1: icmp_seq=4 hlim=64 time=0.570 ms
--- Ping6 statistics for 20::1 in VPN instance vpn1---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.551/0.752/1.208/0.257 ms

Configuring IPv6 MPLS L3VPN inter-AS option C

Network requirements
Site 1 and Site 2 belong to the same VPN. Site 1 accesses the network through PE 1 in AS 100. Site
2 accesses the network through PE 2 in AS 600. PEs in the same AS run IS-IS.
PE 1 and ASBR-PE 1 exchange labeled IPv4 routes by IBGP. PE 2 and ASBR-PE 2 exchange
labeled IPv4 routes by IBGP. PE 1 and PE 2 are MP-EBGP peers to exchange VPNv6 routes.
ASBR-PE 1 and ASBR-PE 2 use their respective routing policies and label the routes received from
each other.
ASBR-PE 1 and ASBR-PE 2 use EBGP to exchange labeled IPv4 routes.
Figure 94 Network diagram
Table 33 Interface and IP address assignment
Device
PE 1
ASBR-PE 1
Interface IP address
Loop0 2.2.2.9/32
GE1/1/1 2001::1/64
S1/1/0 1.1.1.2/8
Loop0 3.3.3.9/32
S1/1/0 1.1.1.1/8
S1/1/1 11.0.0.2/8
Device
PE 2
ASBR-PE 2
361
Interface IP address
Loop0 5.5.5.9/32
GE1/1/1 2002::1/64
S1/1/0 9.1.1.2/8
Loop0 4.4.4.9/32
S1/1/0 9.1.1.1/8
S1/1/1 11.0.0.1/8