HP FlexNetwork HSR6600 Configuration Manual page 103

Step
1. Enter system view.
2. Enter MPLS TE tunnel
interface view.
3. Record routes or record
both routes and labels.
Enabling loop detection
Enabling loop detection also enables the route recording feature, regardless of whether you have
configured the mpls te record-route command. Loop detection enables each node of the tunnel to
detect whether a loop has occurred according to the recorded route information.
To enable loop detection:
Step
1. Enter system view.
2. Enter MPLS TE tunnel
interface view.
3. Enable loop detection.
Setting tunnel setup retry
If the ingress node fails to establish an MPLS TE tunnel, it waits for the retry interval, and then tries to
set up the tunnel again. It repeats this process until the tunnel is established or until the number of
attempts reaches the maximum. If the tunnel cannot be established when the number of attempts
reaches the maximum, the ingress waits for a longer period and then repeats the previous process.
To set tunnel setup retry:
Step
1. Enter system view.
2. Enter MPLS TE tunnel
interface view.
3. Set the maximum number of
tunnel setup attempts.
4. Set the retry interval.
Configuring automatic bandwidth adjustment
Step
1. Enter system view.
2. Enter MPLS TE view.
Command
system-view
interface tunnel tunnel-number [ mode
mpls-te ]
•
To record routes:
mpls te record-route
•
To record both routes and labels:
mpls te record-route label
Command
system-view
interface tunnel tunnel-number
[ mode mpls-te ]
mpls te loop-detection
Command
system-view
interface tunnel tunnel-number
[ mode mpls-te ]
mpls te retry retries
mpls te timer retry seconds
Command
system-view
mpls te
93
Remarks
N/A
N/A
By default, both route
recording and label
recording are disabled.
Remarks
N/A
N/A
By default, loop detection is
disabled.
Remarks
N/A
N/A
By default, the maximum number
of attempts is 3.
By default, the retry interval is 2
seconds.
Remarks
N/A
N/A