Configuring Multirole Host - HP FlexNetwork HSR6600 Configuration Manual

224.0.0.0/4
224.0.0.0/24
255.255.255.255/32 Direct
5. Verify that CE 3 and CE 4 can ping each other. (Details not shown.)
6. Verify that CE 5 and CE 6 can ping each other. (Details not shown.)
7. Verify that CE 3 and CE 6 cannot ping each other. (Details not shown.)

Configuring multirole host

Network requirements
Configure the multirole host feature to allow Host A to access VPN 1 and VPN 2 and Host B to
access only VPN 1.
Figure 80 Network diagram
CE 1
VPN 1
100.1.1.2/24
Host A
Configuration procedure
1. Configure CE 1:
# Configure IP addresses for interfaces.
<CE1> system-view
[CE1] interface gigabitethernet 1/1/1
[CE1-GigabitEthernet1/1/1] ip address 100.1.1.1 24
[CE1-GigabitEthernet1/1/1] quit
[CE1] interface serial 1/1/0
[CE1-Serial1/1/0] ip address 1.1.1.2 24
[CE1-Serial1/1/0] quit
# Configure a default route to PE 1.
[CE1] ip route-static 0.0.0.0 0 1.1.1.1
2. Configure PE 1:
# Create VPN instances vpn1 and vpn2 for VPN 1 and VPN 2, respectively, and configure
different RDs and route targets for the VPN instances.
<PE1> system-view
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
Direct 0
Direct 0
0
MPLS backbone
PE 1
Ser1/1/0
2.1.1.1/24
Ser1/1/1
1.1.1.1/24
Ser1/1/0
1.1.1.2/24
GE1/1/1
100.1.1.1/24
100.1.1.3/24
Host B
0 0.0.0.0
0 0.0.0.0
0 127.0.0.1
PE 2
Ser1/1/0
Ser1/1/1
2.1.1.2/24
3.1.1.2/24
Ser1/1/0
3.1.1.1/24
110.2.1.1/24
296
NULL0
NULL0
InLoop0
CE 2
VPN 2
GE1/1/1
110.2.1.2/24
Host C