HP FlexNetwork HSR6600 Configuration Manual page 261

[Spoke-PE1] mpls ldp
[Spoke-PE1-ldp] quit
[Spoke-PE1] interface pos 1/1/0
[Spoke-PE1-Pos1/1/0] mpls enable
[Spoke-PE1-Pos1/1/0] mpls ldp enable
[Spoke-PE1-Pos1/1/0] quit
# Configure Spoke-PE 2.
[Spoke-PE2] mpls lsr-id 3.3.3.9
[Spoke-PE2] mpls ldp
[Spoke-PE2-ldp] quit
[Spoke-PE2] interface pos 1/1/0
[Spoke-PE2-Pos1/1/0] mpls enable
[Spoke-PE2-Pos1/1/0] mpls ldp enable
[Spoke-PE2-Pos1/1/0] quit
# Configure Hub-PE.
[Hub-PE] mpls lsr-id 2.2.2.9
[Hub-PE] mpls ldp
[Hub-PE-ldp] quit
[Hub-PE] interface pos 1/1/0
[Hub-PE-Pos1/1/0] mpls enable
[Hub-PE-Pos1/1/0] mpls ldp enable
[Hub-PE-Pos1/1/0] quit
[Hub-PE] interface pos 1/1/1
[Hub-PE-Pos1/1/1] mpls enable
[Hub-PE-Pos1/1/1] mpls ldp enable
[Hub-PE-Pos1/1/1] quit
# Execute the display mpls ldp peer command on the devices to verify that that LDP sessions
in Operational state have been established between Spoke-PE 1, Spoke-PE 2, and Hub-PE.
Execute the display mpls ldp lsp command on the devices to verify that the LSPs have been
established by LDP. (Details not shown.)
3. Configure VPN instances on the Spoke-PEs and Hub-PE:
# Configure Spoke-PE 1.
[Spoke-PE1] ip vpn-instance vpn1
[Spoke-PE1-vpn-instance-vpn1] route-distinguisher 100:1
[Spoke-PE1-vpn-instance-vpn1] vpn-target 111:1 import-extcommunity
[Spoke-PE1-vpn-instance-vpn1] vpn-target 222:2 export-extcommunity
[Spoke-PE1-vpn-instance-vpn1] quit
[Spoke-PE1] interface gigabitethernet 1/1/1
[Spoke-PE1-GigabitEthernet1/1/1] ip binding vpn-instance vpn1
[Spoke-PE1-GigabitEthernet1/1/1] ip address 10.1.1.2 24
[Spoke-PE1-GigabitEthernet1/1/1] quit
# Configure Spoke-PE 2.
[Spoke-PE2] ip vpn-instance vpn1
[Spoke-PE2-vpn-instance-vpn1] route-distinguisher 100:2
[Spoke-PE2-vpn-instance-vpn1] vpn-target 111:1 import-extcommunity
[Spoke-PE2-vpn-instance-vpn1] vpn-target 222:2 export-extcommunity
[Spoke-PE2-vpn-instance-vpn1] quit
[Spoke-PE2] interface gigabitethernet 1/1/1
251