HP FlexNetwork HSR6600 Configuration Manual page 475

[PE3-LoopBack0] ip address 3.3.3.9 32
[PE3-LoopBack0] quit
[PE3] mpls lsr-id 3.3.3.9
[PE3] mpls ldp
[PE3-ldp] quit
# Establish IBGP connections to PE 1 and PE 2, and use BGP to advertise VPLS label block
information.
[PE3] bgp 100
[PE3-bgp-default] peer 1.1.1.9 as-number 100
[PE3-bgp-default] peer 1.1.1.9 connect-interface loopback 0
[PE3-bgp-default] peer 2.2.2.9 as-number 100
[PE3-bgp-default] peer 2.2.2.9 connect-interface loopback 0
[PE3-bgp-default] address-family l2vpn
[PE3-bgp-default-l2vpn] peer 1.1.1.9 enable
[PE3-bgp-default-l2vpn] peer 2.2.2.9 enable
[PE3-bgp-default-l2vpn] quit
[PE3-bgp-default] quit
# Enable L2VPN.
[PE3] l2vpn enable
# Configure VSI aaa to use BGP to establish BGP PWs to PE 1 and PE 2.
[PE3] vsi aaa
[PE3-vsi-aaa] auto-discovery bgp
[PE3-vsi-aaa-auto] route-distinguisher 1:1
[PE3-vsi-aaa-auto] vpn-target 1:1
[PE3-vsi-aaa-auto] signaling-protocol bgp
[PE3-vsi-aaa-auto-bgp] site 3 range 10 default-offset 0
[PE3-vsi-aaa-auto-bgp] quit
[PE3-vsi-aaa-auto] quit
[PE3-vsi-aaa] quit
# Bind Layer 3 Ethernet interface GigabitEthernet 1/1/1 to VSI aaa.
[PE3] interface gigabitethernet 1/1/1
[PE3-GigabitEthernet1/1/1] xconnect vsi aaa
[PE3-GigabitEthernet1/1/1] quit
Verifying the configuration
# Verify that two BGP PWs in up state have been established on PE 1.
[PE1] display l2vpn pw verbose
VSI Name: aaa
Peer: 2.2.2.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
Peer: 3.3.3.9
Remote Site: 2
: BGP
: 9 PW State : Up
: 1295 Out Label: 1025
: 1500
: Main
: -
: -
: 0x800000160000001
: 1027
Remote Site: 3
465