Configuring Pcep Session Parameters - HP FlexNetwork HSR6600 Configuration Manual

Step
4. Set the delegation priority of
a PCE.
5. Set the redelegation timeout
interval.
6. Set the CRLSP state timeout
interval.
7. Return to MPLS TE view.
8. Enter MPLS TE tunnel
interface view.
9. Enable CRLSP delegation.

Configuring PCEP session parameters

Step
1. Enter system view.
2. Enter MPLS TE view.
3. Set the path calculation
request timeout time.
4. Set the PCEP session
deadtimer.
5. Set the keepalive interval for
PCEP sessions.
6. Set the minimum acceptable
keepalive interval and the
maximum number of allowed
unknown messages received
from the peer.
Configuring traffic forwarding
Perform the tasks in this section on the ingress node of the MPLS TE tunnel.
Configuring static routing to direct traffic to an MPLS TE
tunnel
Step
1. Enter system view.
Command
pce peer ip-address
delegation-priority priority
pce redelegation-timeout value
pce state-timeout value
quit
interface tunnel tunnel-number
[ mode mpls-te ]
mpls te delegation
Command
system-view
mpls te
pce request-timeout value
pce deadtimer value
pce keepalive interval
pce tolerance { min-keepalive
value | max-unknown-messages
value }
Command
system-view
97
Remarks
By default, the delegation priority
of a PCE is 65535.
A smaller value represents a
higher priority.
By default, the redelegation
timeout interval is 30 seconds.
By default, the CRLSP state
timeout interval is 60 seconds.
The CRLSP state timeout
interval must be greater than or
equal to the redelegation timeout
interval.
N/A
N/A
By default, CRLSP delegation is
disabled.
Remarks
N/A
N/A
By default, the request timeout
time is 10 seconds.
By default, the PCEP session
deadtimer is 120 seconds.
By default, the keepalive
interval is 30 seconds.
By default, the minimum
acceptable keepalive interval is
10 seconds, and the maximum
number of allowed unknown
messages in a minute is 5.
Remarks
N/A