HP FlexNetwork HSR6600 Configuration Manual page 158

# Specify the tunnel destination address as the LSR ID of Router D.
[RouterA-Tunnel1] destination 4.4.4.4
# Specify the tunnel signaling protocol as RSVP-TE.
[RouterA-Tunnel1] mpls te signaling rsvp-te
# Specify the explicit path as pri-path.
[RouterA-Tunnel1] mpls te path preference 1 explicit-path pri-path
# Enable FRR for the MPLS TE tunnel.
[RouterA-Tunnel1] mpls te fast-reroute
[RouterA-Tunnel1] quit
# Verify that the MPLS TE interface Tunnel 1 is up on Router A.
[RouterA] display interface tunnel
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel4 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 10.1.1.1/24 (primary)
Tunnel source unknown, destination 4.4.4.4
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 1911 bytes/sec, 15288 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 1526 packets, 22356852 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel interface on Router A.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
: Tunnel 1
: Up (Main CRLSP up, Shared-resource CRLSP down)
:
: 16802 Tunnel ID
: Normal
: 2.2.2.2 Egress LSR ID
: RSVP-TE Static CRLSP Name
: SE
: -
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: exp1
: TE
: Enabled Record Label
: Enabled Bandwidth Protection : Disabled
148
: 1
: 4.4.4.4
: -
: 0 kbps
: 7
: Enabled