Configuring Routing Between Pes - HP FlexNetwork HSR6600 Configuration Manual

Step
3. Configure the PE as an
IBGP peer.
4. Create the BGP IPv6
unicast family and enter its
view.
5. Enable IPv6 unicast route
exchange with the
specified peer or peer
group.
6. (Optional.) Configure route
redistribution.

Configuring routing between PEs

Step
1. Enter system view.
2. Enter BGP instance view.
3. Configure the remote PE as
the peer.
4. Specify the source interface
for route update packets sent
to the specified peer.
5. Create the BGP VPNv6
address family and enter its
view.
6. Enable BGP VPNv6 route
exchange with the specified
peer.
Configuring BGP VPNv6 route control
BGP VPNv6 route control is configured similarly with BGP route control, except that it is configured in
BGP VPNv6 address family view. For more information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv6 route control:
Step
1. Enter system view.
2. Enter BGP instance view.
Command
peer { group-name |
ipv6-address [ prefix-length ] }
as-number as-number
address-family ipv6 [ unicast ]
peer { group-name |
ipv6-address [ prefix-length ] }
enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct |med med-value |
route-policy
route-policy-name ] * ]
Command
system-view
bgp as-number [ instance
instance-name ]
peer { group-name | ipv4-address
[ mask-length ] } as-number
as-number
peer { group-name | ipv4-address
[ mask-length ] }
connect-interface interface-type
interface-number
address-family vpnv6
peer { group-name | ipv4-address
[ mask-length ] } enable
Command
system-view
bgp as-number [ instance
instance-name ]
332
Remarks
By default, no BGP peers exist.
By default, the BGP IPv6
unicast family is not created.
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
A CE must redistribute its routes
to the PE so the PE can
advertise them to the peer CE.
Remarks
N/A
N/A
By default, no BGP peers exist.
By default, BGP uses the
outbound interface of the best
route to the BGP peer as the
source interface.
By default, the BGP VPNv6
address family is not created.
By default, BGP does not
exchange BGP VPNv6 routes
with any peer.
Remarks
N/A
N/A