HP FlexNetwork HSR6600 Configuration Manual page 278

[PE1-bgp-default-vpnv4] quit
# Establish an EBGP peer relationship with CE 1, and add the learned BGP routes to the
routing table of VPN instance vpn1.
[PE1-bgp-default] ip vpn-instance vpn1
[PE1-bgp-default-vpn1] peer 30.0.0.2 as-number 65001
[PE1-bgp-default-vpn1] address-family ipv4 unicast
[PE1-bgp-default-ipv4-vpn1] peer 30.0.0.2 enable
[PE1-bgp-default-ipv4-vpn1] quit
[PE1-bgp-default-vpn1] quit
[PE1-bgp-default] quit
3. Configure ASBR-PE 1:
# Start IS-IS on ASBR-PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] isis 1
[ASBR-PE1-isis-1] network-entity 10.222.222.222.222.00
[ASBR-PE1-isis-1] quit
# Configure the LSR ID, and enable MPLS and LDP.
[ASBR-PE1] mpls lsr-id 3.3.3.9
[ASBR-PE1] mpls ldp
[ASBR-PE1-ldp] quit
# Configure interface Serial 1/1/0, and enable IS-IS, MPLS, and LDP on the interface.
[ASBR-PE1] interface serial 1/1/0
[ASBR-PE1-Serial1/1/0] ip address 1.1.1.1 255.0.0.0
[ASBR-PE1-Serial1/1/0] isis enable 1
[ASBR-PE1-Serial1/1/0] mpls enable
[ASBR-PE1-Serial1/1/0] mpls ldp enable
[ASBR-PE1-Serial1/1/0] quit
# Configure interface Serial 1/1/1, and enable MPLS on it.
[ASBR-PE1] interface serial 1/1/1
[ASBR-PE1-Serial1/1/1] ip address 11.0.0.2 255.0.0.0
[ASBR-PE1-Serial1/1/1] mpls enable
[ASBR-PE1-Serial1/1/1] quit
# Configure interface Loopback 0, and start IS-IS on it.
[ASBR-PE1] interface loopback 0
[ASBR-PE1-LoopBack0] ip address 3.3.3.9 32
[ASBR-PE1-LoopBack0] isis enable 1
[ASBR-PE1-LoopBack0] quit
# Create routing policies.
[ASBR-PE1] route-policy policy1 permit node 1
[ASBR-PE1-route-policy-policy1-1] apply mpls-label
[ASBR-PE1-route-policy-policy1-1] quit
[ASBR-PE1] route-policy policy2 permit node 1
[ASBR-PE1-route-policy-policy2-1] if-match mpls-label
[ASBR-PE1-route-policy-policy2-1] apply mpls-label
[ASBR-PE1-route-policy-policy2-1] quit
# Start BGP on ASBR-PE 1, and apply the routing policy policy2 to routes advertised to IBGP
peer 2.2.2.9.
[ASBR-PE1] bgp 100
268