Troubleshooting Mpls Te - HP FlexNetwork HSR6600 Configuration Manual

Auto Bandwidth
Min Bandwidth
Collected Bandwidth
[RouterA]display mpls te tunnel-interface Tunnel 3
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Static SRLSP Name
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: -
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
The Service-Class fields show that the CoS values of Tunnel 2 and Tunnel 3 are 3 and 6,
respectively. According to the QoS policy, traffic arrives at GigabitEthernet 1/1/4 of Router A is
assigned CoS 3. So CBTS uses Tunnel 2 to forward the traffic.

Troubleshooting MPLS TE

No TE LSA generated
Symptom
OSPF TE is configured but no TE LSAs can be generated to describe MPLS TE attributes.
: - Auto Bandwidth Freq
: - Max Bandwidth
: - Service-Class
: Tunnel 3
: Up (Main CRLSP up)
:
: 17418 Tunnel ID
: Normal
: 10.1.1.1 Egress LSR ID
: RSVP-TE Static CRLSP Name
: main3/-
: -
: -
: -
: - Reverse-LSP Tunnel ID: -
: - Tunnel Bandwidth
: -
: 0 Holding Priority
: -/-
: -
: TE
: - Record Label
: - Bandwidth Protection : -
Backup Bandwidth Type: -
: -
: - Auto Created
: -
: 3 Retry Interval
: - Reoptimization Freq
: - Backup LSP ID
: - Auto Bandwidth Freq
: - Max Bandwidth
: - Service-Class
162
: -
: -
: 3
: 3
: 40.1.1.1
: -
: -
: 0
: -
: -
: 2 sec
: -
: -
: -
: -
: 6