Step
5.
Configure a TE class.
Table 1 Default TE classes in IETF mode
TE Class
0
1
2
3
4
5
6
7
Configuring an MPLS TE tunnel to use a static
CRLSP
To configure an MPLS TE tunnel to use a static CRLSP, perform the following tasks:
•
Establish the static CRLSP.
•
Specify the MPLS TE tunnel establishment mode as static.
•
Configure the MPLS TE tunnel to use the static CRLSP.
Other configurations, such as tunnel constraints and IGP extension, are not needed.
To configure an MPLS TE tunnel to use a static CRLSP:
Step
1.
Enter system view.
2.
Create a static CRLSP.
3.
Enter MPLS TE tunnel
interface view.
4.
Specify the MPLS TE tunnel
establishment mode as
static.
5.
Apply the static CRLSP to
the tunnel interface.
Command
ds-te te-class te-class-index
class-type
class-type-number priority
priority
CT
0
1
2
3
0
1
2
3
Command
system-view
See "Configuring a static CRLSP."
interface tunnel tunnel-number
[ mode mpls-te ]
mpls te signaling static
mpls te static-cr-lsp lsp-name
85
Remarks
The default TE classes for IETF
mode are shown in
Table
In prestandard mode, you cannot
configure TE classes.
Priority
7
7
7
7
0
0
0
0
Remarks
N/A
N/A
Execute this command on the
ingress node.
By default, MPLS TE uses
RSVP-TE to establish a tunnel.
By default, a tunnel does not use
any static CRLSP.
1.